Honeywell UC 14SD instruction manual English

Page 5

English

*If the input rating of a battery charger is given in watts rather than in amperes, the corresponding ampere rating is to be determined by dividing the wattage rating by the voltage rating–for example:

1250watts

125 volts = 10 amperes

9.Do not operate battery charger with damaged cord or plug-replace them immediately.

10.Do not operate battery charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman.

11.Do not disassemble battery charger; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.

12.To reduce risk of electric shock, unplug charger from receptacle before attempting any maintenance or cleaning. Removing the battery will not reduce this risk.

13.This battery charger might be attached to HITACHI battery operated tools as a standard accessory. In this case, please confirm Instruction Manual of the HITACHI battery operated tools before using the battery charger.

IMPORTANT SAFETY INSTRUCTIONS FOR USE OF THE BATTERY AND BATTERY CHARGER

You must charge the battery before you can use the power tool. Before using the model UC 14SD battery charger, be sure to read all instructions and cautionary statements on it, the battery and in this manual.

REMEMBER: USE ONLY HITACHI BATTERY TYPE EB1414 OTHER TYPES OF BATTERIES MAY BURST AND CAUSE INJURY!

Follow these instructions to avoid the risk of injury:

WARNING: Improper use of the battery or battery charger can lead to serious injury. To avoid these injuries:

1.NEVER disassemble the battery.

2.NEVER incinerate the battery, even if it is damaged or is completely worn out. The battery can explode in a fire.

3.NEVER short-circuit the battery.

4.NEVER insert any objects into the battery charger’s air vents. Electric shock or damage to the battery charger may result.

5.NEVER charge outdoors. Keep the battery away from direct sunlight and use only where there is low humidity and good ventilation.

6.NEVER charge when the temperature is below 50°F (10°C) or above 104°F (40°C).

7.NEVER connect two battery chargers together.

8.NEVER insert foreign objects into the hole for the battery or the battery charger.

9.NEVER use a booster transformer when charging.

10.NEVER use an engine generator or DC power to charge.

11.NEVER store the battery or battery charger in places where the temperature may reach or exceed 104°F (40°C).

5

Image 5
Contents Avertissement Instructions DE Securite ET Mode D’EMPLOIÍndice ContentsTable DES Matieres Meanings of Signal Words Important Safety InformationRead ALL Instructions SafetyEnglish Make Them Available to Other Users Owners of this Tool Disposal of the Exhausted BatteryName of Parts Operation and MaintenanceModel Insert the battery to the battery charger SpecificationsApplications Charging MethodCharging Disconnect battery charger from the receptacleRemove the battery from the battery charger Service and Repairs Maintenance and InspectionBefore USE StorageSignification DES Mots D’AVERTISSEMENT Informations Importantes DE SécuritéSecurite Lire Tout CE Mode DemploiIntensité nominale d’entrée CA ampères Mise AU Rebut D’UNE Batterie Usée NOM DES Parties Utilisation ET EntretienModèle Méthode DE Recharge UtilisationsRetirer la batterie du chargeur de batterie RechargeDébrancher le chargeur de batterie de la prise Entretien ET Inspection Avant L’UTILISATIONVérifier les vis Vérifier s’il y a de la poussièreRangement Service APRES-VENTE ET RéparationsSignificado DE LAS Palabras DE Señalización Información Importante Sobre SeguridadLEA Todas LAS Instrucciones SeguridadTabla Eliminación DE LAS Baterías Agotadas Nomenclatura Operación Y MantenimientoModelo Método DE Carga EspecificacionesAplicaciones Extraiga la batería del cargador de baterías CargaDesconecte el cargador de baterías del tomacorriente Mantenimiento E Inspección Antes DE LA UtilizaciónAlmacenamiento Servicio Y ReparaciónesNota Page Page Page Hitachi Koki Canada Co