Hitachi SJ2002 manual Overload restriction operation mode

Func.				Default	Set
		Name / Description		Value
Code					Value
				–FE(F)/–FU
B021/	Overload restriction operation mode			01
B221	• 00 Disabled
	• 01 Enabled for accel and constant speed
	• 02 Enabled for constant speed only
B022/	Overload restriction setting			Rated
B222				current x 1.5
B023/	Deceleration rate at overload restriction			1.0 / 30.0
B223
B031	Software lock mode selection			01
	• 00 Low-level access, [SFT] blocks edits
	• 01 Low-level access, [SFT] blocks edits
	(except F001 and Multi-speed parameters)
	• 02 No access to edits
	• 03 No access to edits except F001 and Multi-
	speed parameters
	• 03 High-level access, including B031
B080	[AM] analog signal gain			100.
B082	Start frequency adjustment			0.5
B083	Carrier frequency setting			5.0
B084	Initialization mode (parameters or trip history)			00
	•	00 Trip history clear
	•	01 Parameter initialization
	• 02 Trip history clear and parameter
		initialization
B085	Country code for initialization			01 / 02
	• 00 Japan version		• 01 Europe version
	• 02 USA version
B086	Frequency scaling conversion factor			1.0
B087	STOP key enable			00
	• 00 Enable		• 01 Disable
B088	Restart mode after FRS			00
	• 00 Restart from 0Hz
	• 01 Restart from frequency detected from
	actual speed of motor
B090	Dynamic braking usage ratio			0.0
B091	Stop mode selection			00
	• 00 DEC (decelerate and stop)
	• 01 FRS (free-run to stop)
B092	Cooling fan control			00
	• 00 Fan always ON
	• 01 Fan ON during Run, OFF during Stop
	• 02 Fan is temperature-controlled

23