Outback Power Systems FX2348ET, VFX3024E, VFX3048E, VFX2612E, FX2024ET manual Mounting, Aca Dcc Dca

MOUNTING

All OutBack FX’s can be mounted in any position. Better performance will be achieved if it is mounted in a location which allows for air to circulate around the exterior of the casting. Locating the FX in a cool location will improve the operation and ensure the highest efficiency and power capacity.

The following drawing provides the mounting and overall dimensions of the FX with the FXA kit (DCC + ACA + DCA) attached. The first dimension is inches and the second value in parenthesis is the metric value in millimeters.

ACA

DCC

DCA

Depth out from Wall / Height up from Shelf: 11.87 inches (301 mm) / 12.87 INCHES (327mm) with Turbo installed

For installations where the FX may be exposed to water spray, either mount the FX with the base down (shelf mounting) or with the AC wiring compartment at the bottom (wall mounting). This will minimize the entry of water into the AC wiring compartment.

The FX-ACA can be used to add an AC outlet and one or two of OutBack’s AC rated OBDC circuit breakers (up to 70 amps max). When these items are added to the FX, it should only be used in an area that is protected from rain.

AC Wiring Compartment (with Outlet or Circuit Breaker Knock-Outs)

Side view of FX with FXA kit attached. The Turbo Kit adds 1” (25mm) additional height to achieve a total height of 12.87” (327mm)

Installation & Programming Manual	FX & VFX “E” Series Inverter/Charger System	Copyright 2003  OutBack Power Systems, Inc.
	900-0027-2	19009 62nd Ave NE, Arlington WA 98223 USA

Page 10

Rev 7.1 06/08/06 Tel 360 435 6030 Fax 360 435 6019