Outback Power Systems FX2024ET, VFX3024E manual AC Input Frequency Range, Maximum AC Output Current

Page 9

RATINGS

AC INPUT FREQUENCY RANGE:

This is the AC input source’s frequency range that the FX will accept and stay connected. If the AC input source is out of this range, the FX will not connect or stay connected.

All “Export” FXs

45 - 55 Hz

MAXIMUM AC OUTPUT CURRENT:

This is the amount of “Surge” current that the FX will supply. This amount of surge can only be supplied for a split second. After this split second the FX lowers this surge limit. Depending on the size of the surge, the FX can be overloaded for a minimum time of 5 seconds to a maximum time of 30 minutes. When passing an AC source through the FX via the AC transfer switch, the maximum AC output fault current will be determined by the AC source.

All “Export” FXs

25 AAC per FX for 1 millisecond

MAXIMUM CONTINUOUS OUTPUT POWER:

Each FX has a maximum continuous output power it can deliver. This maximum continuous output power is hidden in the model number of the FX. For instance, an FX2012MT has a maximum continuous output power of 2000VA (volt-amps). The last two numbers (12 in this case) can be changed to 0’s because they refer to the battery voltage.

FX2012ET

2000 VA (VA = volt-amps)

FX2024ET

2000 VA

FX2348ET

2300 VA

VFX2612E

2600 VA

VFX3024E

3000 VA

VFX3048E

3000 VA

MAXIMUM OVERCURRENT PROTECTION AMPACITY:

This rating specifies the proper overcurrent protection ampacity. OBDC are panel mount circuit breakers. FX’s used in home installations should use properly sized DC circuit breakers. DC breakers include both overcurrent protection and disconnect capability.

MODEL

AMPACITY

DC BREAKER

FX2012ET

250 amps

OBDC-250

FX2024ET

175 amps

OBDC-175

FX2348ET

100 amps

OBDC-100

VFX2612E

250 amps

OBDC-250

VFX3024E

250 amps

OBDC-250

VFX3048E

175 amps

OBDC-175

Copyright 2003  OutBack Power Systems, Inc.

FX & VFX “E” Series Inverter/Charger System

Installation & Programming Manual

19009 62nd Ave NE, Arlington WA 98223 USA

900-0027-2

 

Tel 360 435 6030 Fax 360 435 6019

Rev 7.1 06/08/06

Page 9

Image 9
Contents Export FX and VFX Inverter/Charger Installation and Programming Manual900-0027-2 Table of Contents Wire Sizes Warranty Registration Stacking InstructionsMate Screens Declaration of Conformity EU Declaration of ConformityImportant Safety Instructions Installation GuidelinesGeneral Precautions Personal Precautions While Working with BatteriesAdditional Notices Ratings AC Input Frequency Range Maximum Continuous Output PowerMaximum AC Output Current Maximum Overcurrent Protection AmpacityACA DCC DCA MountingComplete Outback Integrated Systems Psac Psdc PS2AC PS2DCAC Wiring Connections Battery Temp Remote Temperature Sensor RTS Indicators / Control WiringInverter ON/OFF Auxiliary Output AUX + / AUXDC Battery Terminals Battery FX CablingBattery Terminal Covers Equipment Ground TerminalsFXA Accessory KIT FX AccessoriesFX-ACA AC Conduit Adapter FX-DCA DC Conduit AdapterSlave Master HUB Communication ManagerTurbo KIT Information Single FX System FX System Configuration Single FX SystemParalleled Dual FX System FX System Configuration Paralleled Dual FX SystemParalleled Quad FX System FX System Configuration Paralleled Quad FX SystemFX System Configuration 3 Phase FX System Phase FX SystemSTART-UP & Operation Battery Charging Set Points Battery Charging InstructionsStacking Procedure OutBack & 3-phase Stacking MethodsStack Phase Stacking InstructionsPower Save Level Slave Adjust only Power Save Level Master Adjust onlyStacked System Using OUTBACK’S Parallel Stacking Phase Stacked System 3 FX’S onlySystem Examples Automatic Generator Start Instructions OutBack Mate System Controllers Mate System Controller and DisplayOutBack Mate Menu Structure SETUP/FX/INPUT---P00Mate Buttons GEN‘SOFT’ Keys TOP Setup MainGEN Down Grid GENInverter Control Inverter ControlOFF Srch on OK AC Input Control Mate Menu MAP Mate Menu MAP Summary Screen SUM Status Setup ADVMate Screens ExamplesModes Menu Status ScreensFX MX ModesDown Meter MenuDown UP MeterBatt Battery MenuError Error MenuWarn WarnDiscon Disconnect MenuSell Menu PG3Sell Search Menu Setup ScreensSrch Input SrchInput Menu INC DEC Port SETUP/FX/INPUTSrch Input Main InputAdvanced Screens Password Code 1 4PG2 PG4Inverter Menu INVDownmore Down INC Charger MenuPG1 Grid MenuGrid GEN PG3 ADV/FX/GRIDGenerator Menu PG1 GridOFF Port ADV INV Chgr PG2 Auxiliary MenuPG2 AUX Stack PG4 Down INC PortDEC Port PG2 AUX Stacking MenuStack ADV/FX/STACKSell END of Advanced Menu System Calibration MenuCAL AWG Wire SizesWarranty Two Year Limited Warranty900-0027-2 Registration Extended Warranty Application