Panasonic EY7541 To Change the Belt Hook Location Side, Control Panel, Impact Power Mode Select

3.Release the belt hook lock lever to lock the angle of belt hook.

4.Make sure the belt hook is firmly locked. Also make sure the belt hook is firmly locked into position 3.

• The belt hook cannot be locked in this posi- tion. Firmly lock it into position before use.

To return the belt hook to the storing position, Follow step 1. and 2. above, then lower the belt hook.

To secure the lock, follow 3 and 4 above.

To Change the Belt Hook Location Side

The belt hook can be attached to either side of the unit.

1.Set the belt hook at storing position.

2.Loosen the screw turning it counter- clockwise, using a flat metal or a flat blade screw driver.

3.Take out the belt hook and insert into the other side of the slot on the main unit.

4.Fasten the screw firmly, turning it clock- wise.

The belt hook can be taken out from the main unit only when it is at storing posi- tion.

Control Panel

(4) (3)

(1)

(2)

(1) Impact Power Mode Select

Selecting the impact power among 3 modes (Soft, Medium, Hard).

Press the impact power mode button to set it. The mode changes to hard, medium, or soft each time the button is pressed.

The driver is preset to “hard” impact mode setting when shipped from the manufac- turer.

Recommended work guideline table

Impact	Recommended Application
Power mode
Display
H	Jobs requiring a high level
	of torque where there is
	no possibility of the bolts
	or screw breaking, its top
	shearing off, or the bit coming
0 – 2300 r.p.m.	loose. (This setting provides
	maximum torque.) Suitable
and
	applications include:
0 – 3000 i.p.m.
	Tightening M8 and larger
	bolts
	Tightening long screws
	during interior finishing work
M	Jobs requiring limited torque
	where there is a possibility of
	the screw breaking or its top
	shearing off. (This setting limits
	torque.) Suitable applications
0 – 1400 r.p.m.	include:
and	Tightening bolts with
	smaller diameters (M6)
0 – 2800 i.p.m.
	Tightening metalwork
	screws when installing
	fixtures
S	Jobs requiring limited torque
	where there is a possibility
	of the screw breaking, its
	top shearing off, or the bit
	coming loose and damaging
	a finished exterior surface.
0 – 1000 r.p.m.	(This setting limits torque.)
	Suitable applications include:
and	Tightening bolts smaller
0 – 2000 i.p.m.	than M6 that may shear
	easily
	Tightening screws into
	molded plastic
	Installing gypsum wallboard
* i.p.m. = Impact per minute.
(2) LED light	Pressing the	button
	toggles the LED light on
	and off.
	The light illuminates
	with very low cur-
	rent, and it does not
	adversely affect the

performance of the driver during use or its bat- tery capacity.

CAUTION:

•The built-in LED light is designed to illu- minate the small work area temporarily.

•Do not use it as a substitute for a regu- lar flashlight, since it does not have enough brightness.

This product has the built-in LED light.

- -