Grizzly G0659 owner manual Angle Adjustments, Clamp Vise installation, Clamp Vise Removal

Clamp Vise

Angle Adjustments

1.The lock pins secure the vise angle at 90º. For angles other than 90º, remove the lock pins from the vise. If they do not pull out by hand, turn the lock nuts clockwise to release the pins from their holes (Figure 18).

Clamp Lock

Bolt

Lock Pin

Lock Nut

Figure 18. Clamp vise angle.

2.Loosen the clamp lock bolt, rotate the clamp to the desired angle, then tighten the clamp lock bolt.

C-Clamp Vise installation

1.Place the C-clamp vise over the vise base, then insert the vise rod into the clamp base, as shown in Figure 19.

Vise Rod

Leadscrew

Clamp Base

Figure 19. C-clamp vise.

-18-

2.Turn the leadscrew to tighten the clamp and secure the workpiece. Be sure the clamp is not in the path of the saw blade.

Note: When clamping workpieces at angles, it may be necessary to position the clamp on the other side of the vise to avoid interfering with the blade travel.

C-Clamp Vise Removal

1.Remove the lock pins from the vise by turning the lock nuts clockwise to release the pins from the holes (Figure 20).

Clamp Lock

Screw

Lock Pin

Vise Pin

Lock Nut

Figure 20. C-clamp vise removal.

2.Remove the clamp lock bolt and the entire clamp vise assembly. Use pliers to carefully remove the vise pin from the table.

G0659  9" x 14" Vertical Metal-Cutting Bandsaw