Cutting Depth
To adjust the depth of cut:
1.Use the saw release lever to move the saw to the desired
Feed Rate
The feed rate is the rate at which the saw frame travels. On the Model G0659, the feed rate is controlled hydraulically by a knob on the control panel. The optimal feed rate depends on the type and dimensions of stock being cut as well as the blade being used. The optimal feed rate is deter- mined by observing the chips produced by the cut, as described on Page 33.
To adjust the feed rate:
1.Be sure the saw is at the start position by pushing the saw release lever all the way down (Figure 22).
Stop Clamp
Saw Release Lever
Figure 21. Depth of cut adjust.
NOTICE
This bandsaw will damage the vise and table if the depth of cut and saw frame stop are not properly adjusted. Before making any cuts, check that the blade will not con- tact the table or vise when it is positioned all the way forward.
Saw Release
Knob
Feed Rate
Control Knob
Saw Release
Lever
G0659 9" x 14" Vertical