Woodstock W1678 instruction manual Belt Tension, Front panel and mounting screws

Page 23

Front Panel

Mounting Screw

Figure 36. Front panel and mounting screws.

1"

Figure 37. Belt deflection (1").

Motor

Mounting Nuts

Figure 38. Motor mounting nuts.

V-Belt Tension

The sanding drums are driven by two heavy-duty V-belts. After drum adjustments and normal operation, the belts may need adjustment. The belt looseness or deflection must be approximately 1".

Keep your drum sander unplugged during all assembly, maintenance, and adjustment tasks. Ignoring this warning can cause serious personal injury to you or others!

Make sure you inspect the V-belts correctly when adjusting the belts. Replace both belts even if only one is worn. Otherwise, one belt could slip and break, damaging the sander and injuring you and bystanders!

To inspect / adjust the V-belts, do these steps:

1.Unplug the Double Drum Sander.

2.Remove eight front panel mounting screws and remove the panel. See Figure 36.

3.At the halfway point between the drum pulley and the motor pulley, push on both belts with moderate finger pressure. The looseness or deflection must be approximately 1". See Figure 37.

4.Grab the belts one at a time, twist them, and use a flashlight to inspect the inside and outside of the belt. If you see deep cracks, fraying, chunks missing, or the belt is brittle and glazed; replace both belts.

5.Loosen the motor mounting nuts, and slide the motor on the mounting plate to adjust the belt. See Figure 38.

6.Tighten the motor mounting nuts, recheck and readjust the belts as necessary.

7.Reinstall the front panel.

ADJUSTMENTS

-21-

Image 23
Contents Model W1678 Page Table of Contents About Your New 26 Double Drum Sander Woodstock Service and SupportIntroduction Specifications Warranty and ReturnsStandard Safety Instructions SafetyKeep proper footing and balance at all times SafetyModel W1678 Additional Safety Instructions for Drum SandersNever stand in the path of potential Workpiece kickback Avoiding Potential InjuriesSafety Grounding 220V OperationExtension Cords Unpacking AssemblyBox Contents Shop Preparation Initial Cleaning Dust Port Handles To install dust ports and handles, do these stepsBeginning Crank and Handle To install the control box, do these stepsTo install the crank and handle, do these steps Control BoxUnplug the Double Drum Sander AdjustmentsTo adjust the drum-to-conveyor squareness, do these steps Drums and Pressure Rollers30 gauge block positioning Step To adjust the drum-to-conveyor parallelism, do these steps25⁄8 gauge block positioning Part 3 Drum-to-Conveyor Height To adjust the drum-to-conveyor height, do these stepsTo adjust pressure-roller spring tension, do these steps Part 4 Pressure Roller AdjustmentDust scoop gap Dust Scoop GapFront panel and mounting screws Belt TensionConveyor belt hanging gap Conveyor BeltControl panel offers these controls OperationsOverview Control Panel Operation Basic SandingTo use the double drum sander, do these steps Main power ON/OFF safety switchLoad meter Troubleshooting Long grooves General Sanding Belts MaintenanceLubrication MaintenanceSandpaper Replacement Brush ReplacementSlide the bearing out of the bearing block. See Figure Bearing ReplacementBearing-block grease grove Grease port General Cleaning W1678 26 Double Drum Sander Drive System Wiring DiagramControl System Wiring Diagram Closure Parts Scale 143 146 145 144 142 151 154 110 111 106 105 Pressure Roller 227 Side Panel 337 Magnetic Switch Page Page Page BOX BELLINGHAM, WA Warranty Card