Woodstock W1678 instruction manual 25⁄8 gauge block positioning

Page 19

Figure 25. The 258" gauge block positioning.

Mounting

Nuts

Figure 26. Rear bearing block and nuts.

5.At one end of the rear drum, place the 258" gauge block on the dust collector bar and between both drums. Your goal is to slide the rear drum against the block so the rear drum sanding path runs true with the front drum, which now runs true with the conveyor feed path. See Figure 25.

6.Loosen the left bearing-block mounting nuts at the end of the rear drum just enough to slide the bearing block. See Figure 26.

7.Slide the rear drum and bearing block forward until it stops against the 258" gauge block that is sandwiched between the two drums. The gauge block should just be snugly held against the front drum.

NOTICE

DO NOT over-tighten the bearing block mounting nuts. The bearing blocks are machined housings that can warp or crack if the nuts are over-tightened.

8.Tighten the nuts in an alternating pattern.

9.Repeat Steps 5 through 8, on the opposite end of the rear drum. Alternate the adjustment until the 258" gauge block has the same snug fit between the drums at both ends. The difference between ends must be less than 18". Remember, adjusting one drum-end slightly affects the adjustment at the opposite end.

NOTICE

Make sure the drive belts still have the correct tension. If they are out of adjustment, adjust as outlined in the V-Belt Tension procedure on Page 21.

ADJUSTMENTS

-17-

Image 19
Contents Model W1678 Page Table of Contents Introduction Woodstock Service and SupportAbout Your New 26 Double Drum Sander Specifications Warranty and ReturnsStandard Safety Instructions SafetyKeep proper footing and balance at all times SafetyModel W1678 Additional Safety Instructions for Drum SandersNever stand in the path of potential Workpiece kickback Avoiding Potential InjuriesSafety Extension Cords 220V OperationGrounding Box Contents AssemblyUnpacking Shop Preparation Initial Cleaning Beginning To install dust ports and handles, do these stepsDust Port Handles Crank and Handle To install the control box, do these stepsTo install the crank and handle, do these steps Control BoxUnplug the Double Drum Sander AdjustmentsTo adjust the drum-to-conveyor squareness, do these steps Drums and Pressure Rollers30 gauge block positioning Step To adjust the drum-to-conveyor parallelism, do these steps25⁄8 gauge block positioning Part 3 Drum-to-Conveyor Height To adjust the drum-to-conveyor height, do these stepsTo adjust pressure-roller spring tension, do these steps Part 4 Pressure Roller AdjustmentDust scoop gap Dust Scoop GapFront panel and mounting screws Belt TensionConveyor belt hanging gap Conveyor BeltOverview Control Panel OperationsControl panel offers these controls Operation Basic SandingTo use the double drum sander, do these steps Main power ON/OFF safety switchLoad meter Troubleshooting Long grooves General Sanding Belts MaintenanceLubrication MaintenanceSandpaper Replacement Brush ReplacementSlide the bearing out of the bearing block. See Figure Bearing ReplacementBearing-block grease grove Grease port General Cleaning W1678 26 Double Drum Sander Drive System Wiring DiagramControl System Wiring Diagram Closure Parts Scale 143 146 145 144 142 151 154 110 111 106 105 Pressure Roller 227 Side Panel 337 Magnetic Switch Page Page Page BOX BELLINGHAM, WA Warranty Card