Woodstock W1678 Main power ON/OFF safety switch, To use the double drum sander, do these steps

Page 27

Figure 46. Main power ON/OFF safety switch.

Figure 47. DO NOT stand in the path of where

the workpiece could be projected.

Figure 48. NEVER hold the workpiece where the conveyor and workpiece can pinch your fingers.

NOTICE

ALWAYS take a few moments to listen and observe for unusual noise and vibration after starting the Double Drum Sander.

To use the double drum sander, do these steps:

1.Twist and pull the emergency stop switch knob, and position your finger over the knob. Be ready to push the knob and shut the sander OFF if there is a problem. See Figure 46.

2.Push the sanding drum ON button and listen for any unusual noises. The sander must run smoothly with little or no vibration.

If unusual noise or vibration exists, push the emergency stop switch immediately and unplug the sander.

Troubleshoot the source of the noise or vibration, and correct the problem.

ONLY adjust the sander when it is OFF and unplugged.

ONLY restart the sander when you are sure the problem is corrected.

3.Start your dust collector.

DO NOT stand in the path where the workpiece could be projected. If you ignore this warning you could be severely injured or killed!

4.Place the workpiece on the conveyor table and turn the table height handwheel clockwise to raise the conveyor table until the stock barely touches the pressure roller. See Figure 48.

5.Push the feed motor ON button to start the feed conveyor.

6.See Figures 48 and 49 and feed the workpiece correctly where the conveyor cannot pinch your fingers.

-25-

OPERATIONS

Image 27
Contents Model W1678 Page Table of Contents Woodstock Service and Support IntroductionAbout Your New 26 Double Drum Sander Specifications Warranty and ReturnsStandard Safety Instructions SafetyKeep proper footing and balance at all times SafetyModel W1678 Additional Safety Instructions for Drum SandersNever stand in the path of potential Workpiece kickback Avoiding Potential InjuriesSafety 220V Operation Extension CordsGrounding Assembly Box ContentsUnpacking Shop Preparation Initial Cleaning To install dust ports and handles, do these steps BeginningDust Port Handles Crank and Handle To install the control box, do these stepsTo install the crank and handle, do these steps Control BoxUnplug the Double Drum Sander AdjustmentsTo adjust the drum-to-conveyor squareness, do these steps Drums and Pressure Rollers30 gauge block positioning Step To adjust the drum-to-conveyor parallelism, do these steps25⁄8 gauge block positioning Part 3 Drum-to-Conveyor Height To adjust the drum-to-conveyor height, do these stepsTo adjust pressure-roller spring tension, do these steps Part 4 Pressure Roller AdjustmentDust scoop gap Dust Scoop GapFront panel and mounting screws Belt TensionConveyor belt hanging gap Conveyor BeltOperations Overview Control PanelControl panel offers these controls Operation Basic SandingTo use the double drum sander, do these steps Main power ON/OFF safety switchLoad meter Troubleshooting Long grooves General Sanding Belts MaintenanceLubrication MaintenanceSandpaper Replacement Brush ReplacementSlide the bearing out of the bearing block. See Figure Bearing ReplacementBearing-block grease grove Grease port General Cleaning W1678 26 Double Drum Sander Drive System Wiring DiagramControl System Wiring Diagram Closure Parts Scale 143 146 145 144 142 151 154 110 111 106 105 Pressure Roller 227 Side Panel 337 Magnetic Switch Page Page Page BOX BELLINGHAM, WA Warranty Card