Woodstock W1667 instruction manual Drilling Speed, Loosening the lock knob

Page 19

Drilling Speed

The Model W1667 8 1⁄2'' Oscillating Drill Press has 5 speeds ranging from 620 to 3100 RPM. Refer to the speed charts located under the belt guard while following the instructions below.

UNPLUG the drill press before changing speeds to avoid accidental start up. Failure to do this may result in serious personal injury.

To change the drilling speed, do these steps:

1.UNPLUG THE DRILL PRESS!

2.Refer to the speed chart located under the belt cover or refer to the “Drill Press RPM Chart” on Page 18 and choose the desired speed.

3.Loosen the v-belt tension lock. See Figure 27.

4.Pull the motor toward the front of the drill press to remove tension from the V-belt.

5.Move the V-belt to the desired V-grooves on the motor and spindle pulleys. See

Figure 28.

6.Push the motor toward the back of the headstock, the motor pushrod rod is spring loaded and will follow the motor. See

Figure 29.

7.Tighten the lock knob.

8.Tighten the lock screw, and make sure the belt deflection is 11⁄2" between both inner sides when the belt is pinched together between the pulleys. Refer to “Belt Tension” in the ADJUSTMENTS section on Page 13 for details.

9.Close the cover. The motor will not start until the cover is closed.

Figure 27. Loosening the lock knob.

Figure 28.

Adjusting belt to desired speed.

ADJUSTMENTS

 

Pushrod

Figure 29. Motor support rod follows motor.

-17-

Page 18 Page 20
Image 19
Page 18 Page 20
Contents 81⁄2 Oscillating Drill Press Page Contents About Your W1667 8 1⁄2 Oscillating Drill Press Woodstock Service and SupportSpecifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Standard Safety InstructionsKeep proper footing and balance at all times Additional Safety Instructions for Drill PressesNever drill while holding Workpiece by hand Avoiding Potential InjuriesGrounding 110V OperationExtension Cords Box Contents AssemblyDust Port To install the base and column, do these stepsTo install the dust port, do these steps Base and ColumnLoosely installing table lock lever To install the table, do these stepsAligning the pocket in the headstock With the column HeadstockHandles To install the drill chuck, do these stepsTo install the handles, do these steps Drill ChuckBelt Tension To adjust the drive belt tension, do these stepsFeed Shaft Spring Tension To adjust the feed shaft spring tension, do these stepsHold the spring cover tightly Quill-Shaft ScrewSupport table while loosening lock Table Height / TiltLoosening the lock knob Drilling SpeedTo adjust the drilling depth, do these steps Drill Press RPM ChartDrilling Depth Adjustments Adjustments Starting the Drill Press OperationsTo change drill bits and sanding drums, do these steps Drill/Drum ChangesTo use the oscillating feature, do these steps Using the OscillatorRemove the spindle handles Sanding drum installed Sanding Sleeves GeneralTable and Base LubricationTroubleshooting Parts Diagram Parts List Drill Press Accessories Drill Press Accessories Warranty Card BOX BELLINGHAM, WA
Top Page Image Contents