Woodstock W1667 instruction manual Quill-Shaft Screw, Hold the spring cover tightly

Page 17

7.Engage the next available spring-cover lock slot with the locking lug, and hold the spring lock cover tightly against the side of the headstock. See Figure 21.

8.Snug the cover nut against the spring cover just until the nut stops, and then back-off the nut approximately 13 turn, or just enough so there is no binding anywhere along complete spindle travel.

9.Hold the cover nut and tighten the jam nut against the cover nut. See Figure 21.

Quill-Shaft Screw

While you may never have to adjust the quill- shaft screw, you should understand its function and know how to adjust it should you ever need to remove the quill for cleaning. This screw prevents the quill from rotating during drilling and sanding procedures, and if adjusted incorrectly, the quill may have lash or bind.

UNPLUG your machine during all assembly, adjustments, and mainte-

nance procedures. Otherwise serious person- al injury may occur!

To adjust the quill-shaft screw, do these steps:

1.Unplug the drill press.

2.Clean and lubricate the quill shaft with a thin coat of light oil, and make sure the quill travels freely. See Figure 22.

3.Loosen the jam nut. See Figure 23.

4.Turn the quill-shaft screw clockwise or counterclockwise to establish free, unbind- ing travel while moving the quill up and down through its entire range of travel.

5.When the quill-shaft screw is screwed inward against the quill as far as the screw can go without binding the quill, hold the screw and tighten the jam nut.

6.Recheck for quill binding and looseness while moving the quill up and down

through its entire range of travel and

 

re-adjust as required.

-15-

Cover Nut

Figure 21. Hold the spring cover tightly.

Figure 22. Clean and oil quill shaft.

Jam

Nut

Quill-Shaft

Screw

Figure 23. Typical quill-shaft screw and

jam nut.

ADJUSTMENTS

Image 17
Contents 81⁄2 Oscillating Drill Press Page Contents About Your W1667 8 1⁄2 Oscillating Drill Press Woodstock Service and SupportSpecifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Standard Safety InstructionsKeep proper footing and balance at all times Additional Safety Instructions for Drill PressesNever drill while holding Workpiece by hand Avoiding Potential InjuriesExtension Cords 110V OperationGrounding Box Contents AssemblyTo install the dust port, do these steps To install the base and column, do these stepsBase and Column Dust PortLoosely installing table lock lever To install the table, do these stepsAligning the pocket in the headstock With the column HeadstockTo install the handles, do these steps To install the drill chuck, do these stepsDrill Chuck HandlesBelt Tension To adjust the drive belt tension, do these stepsFeed Shaft Spring Tension To adjust the feed shaft spring tension, do these stepsHold the spring cover tightly Quill-Shaft ScrewSupport table while loosening lock Table Height / TiltLoosening the lock knob Drilling SpeedDrilling Depth Drill Press RPM ChartTo adjust the drilling depth, do these steps Adjustments Adjustments Starting the Drill Press OperationsTo change drill bits and sanding drums, do these steps Drill/Drum ChangesRemove the spindle handles Using the OscillatorTo use the oscillating feature, do these steps Sanding drum installed Table and Base GeneralLubrication Sanding SleevesTroubleshooting Parts Diagram Parts List Drill Press Accessories Drill Press Accessories Warranty Card BOX BELLINGHAM, WA