Woodstock W1667 instruction manual Drill Press RPM Chart, Drilling Depth

Page 20

Drill Press RPM Chart

Use Figure 30 to select the optimum motor-to-spindle pulley ratio for drilling, cutting, and sanding operations. Refer to the Drill, Cutter, and Saw RPM Chart on Page 19 for suggested tool RPMs.

Figure 30. Drill Press RPM Chart.

ADJUSTMENTS

Drilling Depth

Your new drill press comes fitted with a depth stop that allows drilling holes at a preset depth.

NOTICE

BACK-OFF the depth stop completely and secure the stop nuts before using the oscillat- ing feature. If the depth stop is left adjusted for a shallow hole, or the nuts rattle down to the stop while in operation, the depth stop will bottom out and break the oscillator.

To adjust the drilling depth, do these steps:

1.UNPLUG THE DRILL PRESS!

2.Rotate the oscillator pulley until the depth stop pointer indicates “0”. See Figure 30.

3.Loosen the jam nut on the depth stop rod.

4.Move the spindle down while watching the pointer-to-scale relationship and stop at the desired depth.

5.Turn the lower nut while maintaining this depth until the nut comes into contact with the stop flange. See Figure 31.

6.Allow the spindle to return to its original position and tighten the jam nut against the stop nut while making sure the stop nut does not move.

7.Drill a test hole into scrap stock before drilling into any workpiece, and readjust depth stop if necessary.

Depth Stop

Reads “0”

Rotate Oscillator

Pulley Until

Depth Stop Reads

Zero.

Figure 30. Retracting the oscillator for drilling.

Nut

Stop

Flange

Figure 31. Nut contacting stop flange.

-18-

Page 19 Page 21
Image 20
Page 19 Page 21
Contents 81⁄2 Oscillating Drill Press Page Contents Woodstock Service and Support About Your W1667 8 1⁄2 Oscillating Drill PressWarranty and Returns SpecificationsStandard Safety Instructions Disconnect machine when cleaning, adjusting or servicingAdditional Safety Instructions for Drill Presses Keep proper footing and balance at all timesAvoiding Potential Injuries Never drill while holding Workpiece by handExtension Cords 110V OperationGrounding Assembly Box ContentsTo install the base and column, do these steps To install the dust port, do these stepsBase and Column Dust PortTo install the table, do these steps Loosely installing table lock leverHeadstock Aligning the pocket in the headstock With the columnTo install the drill chuck, do these steps To install the handles, do these stepsDrill Chuck HandlesTo adjust the drive belt tension, do these steps Belt TensionTo adjust the feed shaft spring tension, do these steps Feed Shaft Spring TensionQuill-Shaft Screw Hold the spring cover tightlyTable Height / Tilt Support table while loosening lockDrilling Speed Loosening the lock knobDrilling Depth Drill Press RPM ChartTo adjust the drilling depth, do these steps Adjustments Adjustments Operations Starting the Drill PressDrill/Drum Changes To change drill bits and sanding drums, do these stepsRemove the spindle handles Using the OscillatorTo use the oscillating feature, do these steps Sanding drum installed General Table and BaseLubrication Sanding SleevesTroubleshooting Parts Diagram Parts List Drill Press Accessories Drill Press Accessories Warranty Card BOX BELLINGHAM, WA
Top Page Image Contents