Woodstock W1667 Avoiding Potential Injuries, Never drill while holding Workpiece by hand

Page 8

Avoiding Potential Injuries

SAFETY

Figure 1. Never drill while holding the

workpiece by hand.

Figure 2. Keep fingers away from spinning drill

bits, cutters, and sanding surfaces.

Figure 3. Remove switch safety key when

not in use.

Figure 4. Remove handles when using the

oscillating sanding feature.

-6-

Image 8
Contents 81⁄2 Oscillating Drill Press Page Contents Woodstock Service and Support About Your W1667 8 1⁄2 Oscillating Drill PressWarranty and Returns SpecificationsStandard Safety Instructions Disconnect machine when cleaning, adjusting or servicingAdditional Safety Instructions for Drill Presses Keep proper footing and balance at all timesAvoiding Potential Injuries Never drill while holding Workpiece by handExtension Cords 110V OperationGrounding Assembly Box ContentsTo install the base and column, do these steps To install the dust port, do these stepsBase and Column Dust PortTo install the table, do these steps Loosely installing table lock leverHeadstock Aligning the pocket in the headstock With the columnTo install the drill chuck, do these steps To install the handles, do these stepsDrill Chuck HandlesTo adjust the drive belt tension, do these steps Belt TensionTo adjust the feed shaft spring tension, do these steps Feed Shaft Spring TensionQuill-Shaft Screw Hold the spring cover tightlyTable Height / Tilt Support table while loosening lockDrilling Speed Loosening the lock knobDrilling Depth Drill Press RPM ChartTo adjust the drilling depth, do these steps Adjustments Adjustments Operations Starting the Drill PressDrill/Drum Changes To change drill bits and sanding drums, do these stepsRemove the spindle handles Using the OscillatorTo use the oscillating feature, do these steps Sanding drum installed General Table and BaseLubrication Sanding SleevesTroubleshooting Parts Diagram Parts List Drill Press Accessories Drill Press Accessories Warranty Card BOX BELLINGHAM, WA