Woodstock W1667 instruction manual Troubleshooting

Page 28

Troubleshooting

Use this table to isolate and correct any problems with your drill press. If you cannot correct a problem, contact Woodstock International, Inc. at 1-360-734-3482 or tech-support@shopfox.biz.

MAINTENANCE

-26-

Image 28

Contents 81⁄2 Oscillating Drill Press Page Contents Woodstock Service and Support About Your W1667 8 1⁄2 Oscillating Drill PressWarranty and Returns SpecificationsStandard Safety Instructions Disconnect machine when cleaning, adjusting or servicingAdditional Safety Instructions for Drill Presses Keep proper footing and balance at all timesAvoiding Potential Injuries Never drill while holding Workpiece by handGrounding 110V OperationExtension Cords Assembly Box ContentsTo install the base and column, do these steps To install the dust port, do these stepsBase and Column Dust PortTo install the table, do these steps Loosely installing table lock leverHeadstock Aligning the pocket in the headstock With the columnTo install the drill chuck, do these steps To install the handles, do these stepsDrill Chuck HandlesTo adjust the drive belt tension, do these steps Belt TensionTo adjust the feed shaft spring tension, do these steps Feed Shaft Spring TensionQuill-Shaft Screw Hold the spring cover tightlyTable Height / Tilt Support table while loosening lockDrilling Speed Loosening the lock knobTo adjust the drilling depth, do these steps Drill Press RPM ChartDrilling Depth Adjustments Adjustments Operations Starting the Drill PressDrill/Drum Changes To change drill bits and sanding drums, do these stepsTo use the oscillating feature, do these steps Using the OscillatorRemove the spindle handles Sanding drum installed General Table and BaseLubrication Sanding SleevesTroubleshooting Parts Diagram Parts List Drill Press Accessories Drill Press Accessories Warranty Card BOX BELLINGHAM, WA