Woodstock W1667 instruction manual Headstock, Aligning the pocket in the headstock With the column

Page 13

Headstock

The headstock must be tightened in position with the setscrew so the headstock is aligned with the drill press base for balance and weight distribution. DO NOT over tighten the set screw and strip the threads or bend the column.

GET assistance before beginning the next step. The headstock is a heavy load.

To install the headstock, do these steps:

1.With an assistant, position the pocket over the column and allow the headstock to slide down until the column fully seats up and into the headstock (approximately 2"). See Figure 10.

2.Align the headstock directly over the foot of the base as viewed from the front of the drill press.

3.Tighten the two setscrews to secure the headstock to the column. See Figure 11.

Figure 10. Aligning the pocket in the headstock

with the column.

Set screws

ASSEMBLY

Figure 11. Securing the headstock to the

column.

-11-

Image 13

Contents 81⁄2 Oscillating Drill Press Page Contents About Your W1667 8 1⁄2 Oscillating Drill Press Woodstock Service and SupportSpecifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Standard Safety InstructionsKeep proper footing and balance at all times Additional Safety Instructions for Drill PressesNever drill while holding Workpiece by hand Avoiding Potential InjuriesGrounding 110V OperationExtension Cords Box Contents AssemblyTo install the dust port, do these steps To install the base and column, do these stepsBase and Column Dust PortLoosely installing table lock lever To install the table, do these stepsAligning the pocket in the headstock With the column HeadstockTo install the handles, do these steps To install the drill chuck, do these stepsDrill Chuck HandlesBelt Tension To adjust the drive belt tension, do these stepsFeed Shaft Spring Tension To adjust the feed shaft spring tension, do these stepsHold the spring cover tightly Quill-Shaft ScrewSupport table while loosening lock Table Height / TiltLoosening the lock knob Drilling SpeedTo adjust the drilling depth, do these steps Drill Press RPM ChartDrilling Depth Adjustments Adjustments Starting the Drill Press OperationsTo change drill bits and sanding drums, do these steps Drill/Drum ChangesTo use the oscillating feature, do these steps Using the OscillatorRemove the spindle handles Sanding drum installed Table and Base GeneralLubrication Sanding SleevesTroubleshooting Parts Diagram Parts List Drill Press Accessories Drill Press Accessories Warranty Card BOX BELLINGHAM, WA