Woodstock W1667 Using the Oscillator, To use the oscillating feature, do these steps

Page 25

Using the Oscillator

One of the great features of the Model W1667

8 1⁄2'' Oscillating Drill Press is its sanding capa- bility. The drill press can be converted from drilling operations to sanding operations in just a few steps.

UNPLUG the machine and remove all handles before using the oscillating fea- ture. The handles swing during operation.

To use the oscillating feature, do these steps:

1.UNPLUG THE DRILL PRESS!

2.Remove the spindle handles.

3.Lift the belt cover and remove the round belt located on the storage bracket under the speed chart. See Figure 36.

4.Stretch the belt onto the top groove in the spindle and oscillating pulley. See Figure 37.

5.Close the cover. The motor will not start until the cover is closed.

6.Loosen the jam nut for the depth stop and adjust both nuts until they are positioned at the top of the depth stop rod. Tighten the jam nut. See Figure 38.

NOTICE

ALWAYS back-off the depth stop complete- ly and secure the depth stop nuts before using the oscillating feature. If the depth stop is left adjusted for a shallow hole, or the nuts rattle down to the stop while in operation, the depth stop will bottom out and break the oscillator.

Belt and

storage bracket

Figure 36. Oscillator belt on storage bracket.

Figure 37. Stretch the belt to fit on pulleys.

Figure 38. Back-off the depth stop nuts.

OPERATIONS

-23-

Image 25

Contents 81⁄2 Oscillating Drill Press Page Contents About Your W1667 8 1⁄2 Oscillating Drill Press Woodstock Service and SupportSpecifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Standard Safety InstructionsKeep proper footing and balance at all times Additional Safety Instructions for Drill PressesNever drill while holding Workpiece by hand Avoiding Potential InjuriesGrounding 110V OperationExtension Cords Box Contents AssemblyTo install the dust port, do these steps To install the base and column, do these stepsBase and Column Dust PortLoosely installing table lock lever To install the table, do these stepsAligning the pocket in the headstock With the column HeadstockTo install the handles, do these steps To install the drill chuck, do these stepsDrill Chuck HandlesBelt Tension To adjust the drive belt tension, do these stepsFeed Shaft Spring Tension To adjust the feed shaft spring tension, do these stepsHold the spring cover tightly Quill-Shaft ScrewSupport table while loosening lock Table Height / TiltLoosening the lock knob Drilling SpeedTo adjust the drilling depth, do these steps Drill Press RPM ChartDrilling Depth Adjustments Adjustments Starting the Drill Press OperationsTo change drill bits and sanding drums, do these steps Drill/Drum ChangesTo use the oscillating feature, do these steps Using the OscillatorRemove the spindle handles Sanding drum installed Table and Base GeneralLubrication Sanding SleevesTroubleshooting Parts Diagram Parts List Drill Press Accessories Drill Press Accessories Warranty Card BOX BELLINGHAM, WA