Woodstock M1039 manual Small Lock

D('*0()$Jg\\[;i`ccGi\jj

J<KLG

+% Place the rack inside of the table bracket, mesh it together with the pinion, and slide the table sup- port/rack assembly over the column, as shown in =`^li\((.

,% Slide the column ring over the column with the bev- eled edge facing down (=`^li\()), fit the beveled edge of the column ring over the rack, and tighten the setscrew.

Efk\1 DXb\jli\k_\iXZb`jj\Xk\[]`idcp`ek_\ cfn\ii`e^Y\]fi\k`^_k\e`e^k_\j\kjZi\n%;fefk fm\i$k`^_k\ek_\j\kjZi\nfipfldXpjgc`kk_\Zfc$ ldei`e^%

-%Install the crank handle over the pinion shaft, and tighten the setscrew in the crank handle against the flat part of the pinion shaft.

.% Thread the handle into the crank handle.

/% Thread the large lock lever into the back of the table bracket approximately three turns, for now.

0% Thread the small lock lever into the front part of the table bracket approximately three turns, for now. The assembly should now be assembled as shown in =`^li\(*.

=`^li\((% Sliding table bracket and rack

over column.

=`^li\()% Correct column ring

orientation.

Large Lock	Crank Handle
Lever
Small Lock
Lever

=`^li\(*% Handles and lock levers

installed.

-14-