Woodstock M1039 manual ?\XjkfZb

D('*0()$Jg\\[;i`ccGi\jj

?\X[jkfZb

The headstock must be mounted on the column/base assembly before the drill press can be operated. Moving and installing the headstock is a two-person job, at the very least. Although the headstock can be lifted directly onto the column while upright, doing so is difficult and potentially dangerous because of the heavy weight involved. We recommend sliding the column into the headstock, then tilting the entire assembly fully upright, as described and shown in this section.

Kfdflekk_\_\X[jkfZbfekfk_\Zfclde#[fk_\j\ jk\gj1

(% Set the top piece of the headstock styrofoam pack- ing approximately six feet away from the column/ base assembly.

)% Remove the headstock from the box and place it on the styrofoam packing piece you laid out in Jk\g(.

Efk\1 KfXmf`[[XdX^`e^k_\dXZ_`e\#Y\ZXi\]lc efkkf_fc[k_\_\X[jkfZbYpk_\jn`kZ_fik_\kfg gXikf]k_\Y\ckZfm\in_\ec`]k`e^%

*% Carefully lay the column/base on its side.

+% Slide the column all the way into the bottom of the headstock (approximately 4"—6").

,% Tilt the entire assembly up (see =`^li\(+) and carefully position the drill press on its base in the fully upright position.

-%Center a tape or ruler on the base, and suspend a plumb bob from the center of the headstock spindle so it is over the tape/ruler as shown in =`^li\(,.

.% Center the headstock directly over the base as indi- cated by the plumb bob and ruler.

/% Tighten the two headstock setscrews to the column, as shown in =`^li\(-.

=`^li\(+% Mounting the headstock.

=`^li\(,% Aligning headstock with base.

J<KLG

=`^li\(-%Securing the headstock.

-15-