Woodstock M1039 manual 8iYfiI\dfmXc, Kfi\dfm\k\i`ccZlZbXeXiYfi#fk\j\jk\gj1

D('*0()$Jg\\[;i`ccGi\jj

8iYfiI\dfmXc

The arbor can be removed to install other Morse Taper tooling in the spindle. A drift key is included to help remove the arbor or other tooling from the spindle. Usually, once the chuck and arbor have been properly mounted together, they are considered semi-perma- nent connections. (If you would like to install a differ- ent chuck, we recommend getting a new arbor for that chuck.)

Kfi\dfm\k_\[i`ccZ_lZbXe[XiYfi#[fk_\j\jk\gj1

(% UNPLUG THE DRILL PRESS!

)% Rotate the spindle handles until the drift key slot is exposed in the side of the quill.

*% Tighten the lower jam nut against the depth stop bracket. The quill should not return up into the head casting when the depth stop is adjusted this way.

+% Rotate the spindle until the inner drift key slot is aligned with the outer slot, as shown in =`^li\)/. You will see through the spindle when the slot is properly aligned.

,% Insert the drift key into the drift key slot.

-%Hold a downfeed handle with one hand, and slightly loosen the lower jam nut with the other hand. This will allow the quill to rise, trapping the drift key.

.% Hold the drill chuck with one hand, and tap on the drift key with a rubber or wooden mallet, as shown in =`^li\)0, until the arbor releases from the spin- dle taper.

/% Hold a downfeed handle with one hand, and loosen the lower jam nut with the other hand.

Both Slots

Aligned

=`^li\)/% Drift key slots aligned.

Drift Key

=`^li\)0% Arbor removal.

FG<I8K@FEJ

0% Carefully retract the quill into the head stock.

-25-