Simrad SIMRAD HS50 About this manual, Definitions, abbreviations and acronyms

Page 11

INTRODUCTION

1.2About this manual

 

This manual is intended as a reference guide for operating,

 

installing and maintaining the HS50 Heading Sensor. Please

 

take time to read this manual to get thorough understanding of

 

the operation and system components.

 

In this manual the following notations are used:

Caution!

Used to make the user aware of procedures and operational

 

practice which, if not followed, may result in degraded

 

performance or damage to the equipment.

Note!

Used to draw the user's attention to special features or behavior

 

of the equipment.

1.3Definitions, abbreviations and acronyms

Definitions

Alignment The process of adjusting the current internal navigation frame (sensor-frame) in the instrument to the true vessel body frame.

Heading The direction of the main axis (bow direction) of the vessel. This is opposed to course, which is the direction of the vessel motion.

Yaw A rotation about the vertical axis and is positive when turning eastward when the vehicle cruises in north direction. Normally yaw means the dynamic yaw motion.

20221081 / F

3

Image 11
Contents Simrad HS50 Heading Sensor Copyright 20221081 / F Document revisions Contents Operating Instructions Figures and Drawings This page Intentially Left Blank HS50 System components Introduction20221081 / F Definitions About this manualDefinitions, abbreviations and acronyms Nmea Abbreviations and acronymsRestrictions in use Health, environment and safetyRestrictions in guarantee Display unit Physical dimensionsPerformance data Sensor unitProcessing unit PowerEnvironmental specification Processing unit to sensor unit cable CableInterface Grounding GeneralCable connection Location of the unit Sensor unitMechanical installation Bracket mounting option Pedestal mounting option Cable wiringDisplay unit Waterproofing the connectorsAlternative panel mounting Panel mountingBracket mounting option Display unit cable Processing unit Cable connections Display Unit Sensor Unit AP9MK3 Autopilot Connecting to Simrad equipmentRGC Signal Interface unit IS15 Instruments J50/J300X Junction unitNI300X Simrad RA40/RA50 Radar RGC12 Gyro CompassSoftware setup procedure Example Display AdjustmentsDifferential corrections All six serial lines may be used simultaneously Data outputGeneral EthernetDatum Height aidingVelocity filtering Radar formatHDT-Q Expert setupHeading offset Run modeExample Overview Operating InstructionsPerformance monitoring Turning the system ON/OFF348 Navigation/POS display Navigation/HDT displayHdop Pdop Info displaysGps hdt Deviation Accuracy Last heading Common sat Alarms Invalid Position and Heading alarm Invalid Position alarmInvalid Heading alarm Height aided GPS position OperationThis page Intentially Left Blank Periodic maintenance MaintenanceRe-calibration of the Sensor unit Software upgradesReplacing damaged units TroubleshootingRepairs and modifications Replacing damaged cablesNo valid data No responseInvalid Heading No Differential correctionsSimulated data Reduced heading indicationFigures and Drawings Seatex DimensionsKongsberg Seatex Sensor unit bracket, dimensionsSensor unit Processing unit, dimensions Display unit, dimensions Documentation Standard deliveryOptional equipment