Simrad SIMRAD HS50 manual Cable connections

Page 27

INSTALLATION

Cable connections

Proceed as follows to connect the cables to the Processing unit:

1Remove the bottom cover (terminal cover) to get access to the plug-in terminals.

2Strip 1 cm (0.4") of the cable's insulation and pull the screen backward to cover the insulation. Position the straps as shown in the figure below and tighten well to make sure the screen has good contact.

3Provide sufficient wire length so that the plug-in terminals can be easily connected/disconnected.

4Pull out each terminal before connecting the wires. Remove all stands before putting on the terminal cover.

20221081 / F

19

Image 27

Contents Simrad HS50 Heading Sensor Copyright 20221081 / F Document revisions Contents Operating Instructions Figures and Drawings This page Intentially Left Blank HS50 System components Introduction20221081 / F About this manual Definitions, abbreviations and acronymsDefinitions Nmea Abbreviations and acronymsHealth, environment and safety Restrictions in guaranteeRestrictions in use Display unit Physical dimensionsPerformance data Sensor unitPower Environmental specificationProcessing unit Cable InterfaceProcessing unit to sensor unit cable General Cable connectionGrounding Location of the unit Sensor unitMechanical installation Bracket mounting option Pedestal mounting option Cable wiringDisplay unit Waterproofing the connectorsAlternative panel mounting Panel mountingBracket mounting option Display unit cable Processing unit Cable connections Display Unit Sensor Unit Connecting to Simrad equipment RGC Signal Interface unitAP9MK3 Autopilot J50/J300X Junction unit NI300XIS15 Instruments Simrad RA40/RA50 Radar RGC12 Gyro CompassSoftware setup procedure Example Display AdjustmentsDifferential corrections All six serial lines may be used simultaneously Data outputGeneral EthernetDatum Height aidingVelocity filtering Radar formatHDT-Q Expert setupHeading offset Run modeExample Overview Operating InstructionsPerformance monitoring Turning the system ON/OFF348 Navigation/POS display Navigation/HDT displayHdop Pdop Info displaysGps hdt Deviation Accuracy Last heading Common sat Alarms Invalid Position alarm Invalid Heading alarmInvalid Position and Heading alarm Height aided GPS position OperationThis page Intentially Left Blank Periodic maintenance MaintenanceRe-calibration of the Sensor unit Software upgradesReplacing damaged units TroubleshootingRepairs and modifications Replacing damaged cablesNo valid data No responseInvalid Heading No Differential correctionsSimulated data Reduced heading indicationFigures and Drawings Seatex DimensionsKongsberg Seatex Sensor unit bracket, dimensionsSensor unit Processing unit, dimensions Display unit, dimensions Standard delivery Optional equipmentDocumentation