Simrad SIMRAD HS50 manual Operating Instructions, Overview

Page 41

OPERATING INSTRUCTIONS

4. OPERATING INSTRUCTIONS

4.1Overview

HDT

POS

The Display unit is used for setup and operation of the HS50. Each of the push buttons is clearly identified with the primary function in large text, and a secondary function listed in smaller text. Each button provides you with the ability to access a primary display, a secondary display and/or multiple function displays.

Adjustable settings are provided in the SETUP mode. The settings allow adjustment of mounting orientation, selection of differential correction, setup of output serial line formats, Ethernet and the display. Refer Software setup procedure, page 21.

HDT

POS

pfjo^a=epRM

The Display unit consists of the main elements as listed below.

	FUNCTION	REF.
	FUNCTION	PAGE
		PAGE
	Power on/off.	34
	Displays Navigation/HDT display with compass rose or	36
	details.	36
	details.
	Displays Navigation/POS with position and accuracy ellipse.	36

Displays SETUP menu.	21
Used for maneuvering in the SETUP submenus.	21
Used for displaying additional system information.	37

20221081 / F

33

Image 41

Contents Simrad HS50 Heading Sensor Copyright 20221081 / F Document revisions Contents Operating Instructions Figures and Drawings This page Intentially Left Blank HS50 System components Introduction20221081 / F Definitions About this manualDefinitions, abbreviations and acronyms Nmea Abbreviations and acronymsRestrictions in use Health, environment and safetyRestrictions in guarantee Performance data Physical dimensionsSensor unit Display unitProcessing unit PowerEnvironmental specification Processing unit to sensor unit cable CableInterface Grounding GeneralCable connection Location of the unit Sensor unitMechanical installation Bracket mounting option Pedestal mounting option Cable wiringDisplay unit Waterproofing the connectorsAlternative panel mounting Panel mountingBracket mounting option Display unit cable Processing unit Cable connections Display Unit Sensor Unit AP9MK3 Autopilot Connecting to Simrad equipmentRGC Signal Interface unit IS15 Instruments J50/J300X Junction unitNI300X Simrad RA40/RA50 Radar RGC12 Gyro CompassSoftware setup procedure Example Display AdjustmentsDifferential corrections All six serial lines may be used simultaneously Data outputGeneral EthernetVelocity filtering Height aidingRadar format DatumHDT-Q Expert setupHeading offset Run modeExample Overview Operating InstructionsPerformance monitoring Turning the system ON/OFF348 Navigation/POS display Navigation/HDT displayHdop Pdop Info displaysGps hdt Deviation Accuracy Last heading Common sat Alarms Invalid Position and Heading alarm Invalid Position alarmInvalid Heading alarm Height aided GPS position OperationThis page Intentially Left Blank Periodic maintenance MaintenanceRe-calibration of the Sensor unit Software upgradesRepairs and modifications TroubleshootingReplacing damaged cables Replacing damaged unitsNo valid data No responseInvalid Heading No Differential correctionsSimulated data Reduced heading indicationFigures and Drawings Seatex DimensionsKongsberg Seatex Sensor unit bracket, dimensionsSensor unit Processing unit, dimensions Display unit, dimensions Documentation Standard deliveryOptional equipment