Simrad SIMRAD HS50 manual Bracket mounting option

Page 20

Simrad HS50 Heading Sensor

Bracket mounting (option)

An optional mounting bracket (part no. 20213039) can be delivered from Simrad by request.

Assemble the mounting bracket to the Sensor unit with the four screws with washers as shown in the figure below.

4

11

12

10

Holder

Cable ties

Connector with self-bonding tape

Connect the cable from the Processing unit to the cable as described in page 11.

Cable duct

12	20221081 / F

Image 20

Contents Simrad HS50 Heading Sensor Copyright 20221081 / F Document revisions Contents Operating Instructions Figures and Drawings This page Intentially Left Blank Introduction HS50 System components20221081 / F Definitions About this manualDefinitions, abbreviations and acronyms Abbreviations and acronyms NmeaRestrictions in use Health, environment and safetyRestrictions in guarantee Physical dimensions Performance dataSensor unit Display unitProcessing unit PowerEnvironmental specification Processing unit to sensor unit cable CableInterface Grounding GeneralCable connection Sensor unit Location of the unitMechanical installation Bracket mounting option Cable wiring Pedestal mounting optionWaterproofing the connectors Display unitPanel mounting Alternative panel mountingBracket mounting option Display unit cable Processing unit Cable connections Display Unit Sensor Unit AP9MK3 Autopilot Connecting to Simrad equipmentRGC Signal Interface unit IS15 Instruments J50/J300X Junction unitNI300X RGC12 Gyro Compass Simrad RA40/RA50 RadarSoftware setup procedure Display Adjustments ExampleDifferential corrections Data output All six serial lines may be used simultaneouslyEthernet GeneralHeight aiding Velocity filteringRadar format DatumExpert setup HDT-QRun mode Heading offsetExample Operating Instructions OverviewTurning the system ON/OFF Performance monitoring348 Navigation/HDT display Navigation/POS displayInfo displays Hdop PdopGps hdt Deviation Accuracy Last heading Common sat Alarms Invalid Position and Heading alarm Invalid Position alarmInvalid Heading alarm Operation Height aided GPS positionThis page Intentially Left Blank Maintenance Periodic maintenanceSoftware upgrades Re-calibration of the Sensor unitTroubleshooting Repairs and modificationsReplacing damaged cables Replacing damaged unitsNo response No valid dataNo Differential corrections Invalid HeadingReduced heading indication Simulated dataFigures and Drawings Dimensions SeatexSensor unit bracket, dimensions Kongsberg SeatexSensor unit Processing unit, dimensions Display unit, dimensions Documentation Standard deliveryOptional equipment