Intended Use
This tool projects plumb and horizontal points and is intended for accurate transfer and
alignment of plumb, level, graded and
Preparation
Inserting/Replacing the Battery | counterclockwise direction to the | position. |
Alkaline batteries are recommended for the tool.
To open the battery compartment 3, turn the latch 2 in clockwise direction to position 
and pull off the battery lid. Insert the batteries provided.
When inserting, pay attention to the correct polarity according to the representation on the inside of the battery compartment.
Position the battery lid to the bottom of the housing and then push it upward. To lock the battery lid, turn the latch 2 in
When the laser beams flash slowly during operation,the batteries are low. When the flashing begins, the tool can be operated for approx. 8 h.
Always replace all batteries at the same time. Only use batteries from one brand and with the identical capacity.
•Remove the batteries from the tool when not using it for extended periods. When storing for extended periods, the batteries can corrode and discharge themselves.
Features
The numbering of the product features shown refers to the illustration of the tool on the graphic page.
1Exit opening for laser beam
2Latch of battery lid
3Battery lid
4On/Off switch
5Laser warning label
6Tripod mount 1/4"
7Serial number
8
9Locking screw for
10Screw holes of
11Opening for strap attachment
12Magnets
131/4" tripod mount on
145/8" tripod mount on
15Measurement plate with stand*
16Belt Pouch
17Laser viewing glasses*
18Tripod*
*The accessories illustrated or described are not included as standard delivery.
Technical Data
Working range (typical) | 100 ft (30m) | |
Leveling Accuracy |
|
|
Minimum Factory |
|
|
Accuracy | +/- 0.3mm/m (0.0036in/ft) | |
Typical Accuracy |
| up to 1/4 at 100 ft |
– longitudinal axis |
| ±5° |
– lateral axis |
| ±3° |
Leveling duration, typically | <4s | |
Operating temperature | 14 °F... 122 °F | |
|
| |
Storage temperature | ||
| ( | |
Relative air humidity, |
| |
max. |
| 90 % |
Laser class |
| 2 |
Laser type |
| 635 nm, <1 mW |
Tripod mount |
| |
Batteries | 3 x 1.5 V LR6 (AA) | |
Operating lifetime, approx. | 24 h | |
Weight according to | ||
01/2003 |
| 0.5lb (0.25kg) |
Dimensions |
| |
|
| (108x 80 x 40mm) |
Degree of protection |
| IP 5X |
Please observe the article number on the type plate of your tool. The trade names of the individual tools may vary.