Epson D55170 manual Units Without a Dual Voltage Switch, Units with a Dual Voltage Switch

Page 11

English

purchased at your local hardware or electrical

supply store. Follow the cord plug manufacturer installation procedures, contact your local DEWALT Service Center, qualified electrician or call 1-800-4-DEWALTfor proper procedures to install the plug. The compressor must comply with all local and national electrical codes after the 230 volt plug is

installed.

The compressor with the 230 volt plug should only be connected to an outlet having the same configuration as the plug illustrated.

DUAL CONTROL

(D55390, D55395, D55570, D55575, D55580, D55585)

NOTE: Unit must remain running while performing the following adjustments

WARNING : Aftercooler, pump head, and surrounding parts are very hot; do not touch. (see the Hot Surfaces identified on page 2)

WARNING - Moving Parts: Keep your hair, clothing and gloves away from moving parts. Loose clothing, jewelry, or long hair can be caught in moving parts. Air vents may cover moving parts and should be avoided as well.

MOTOR REQUIREMENTS

UNITS WITHOUT A DUAL VOLTAGE SWITCH

WARNING: Make sure motor is disconnected from the power source before rewiring motor leads.

The motor supplied with your compressor is a dual voltage, 115 / 230 volt motor. If it is desired to operate your compressor at 230 volts, single phase, it is necessary to reconnect the motor leads in the motor junction box by following the instructions given on the motor nameplate. If unsure on how to reconnect the motor leads contact your local DEWALT Service Center or qualified electrician for proper procedures to install the plug.

WARNING: Make sure that the 230 volt cord plug end is properly

Stop Start Mode

1.Turn compressor on. If the tank has been fully charged, bleed air from the drain valves until pump starts.

2.Turn knob on top of pilot valve (H) clockwise until fully closed.

WARNING : Over tightening of this knob can cause damage to the pilot valve.

3.Allow compressor to reach cut out pressure. If compressor does not stop, drain the tank(s) until compressor begins to charge the tank(s) and readjust pilot valve knob.

H

connected before operating in 230 volt mode.

UNITS WITH A DUAL VOLTAGE SWITCH

WARNING: Make sure that the 230 volt cord plug end is properly connected before operating in 230 volt mode.

The motor supplied with your compressor is a dual voltage, 115/230 volt motor. If it is desired to operate your compressor at 230 volts, single phase, simply move the 115/230 volt switch to the 230 volt position.

Constant Run Mode

1.Turn compressor on. If the tank has been fully charged, bleed air from the drain valves until pump starts.

2.Turn knob on top of pilot valve (H) fully counter-clockwise until fully open.

WARNING : Over loosening of this knob can cause damage to the pilot valve.

3.Verify that the unit is in a constant run mode. If compressor shuts off, adjust pilot valve to a lower cut out pressure until unit continues to run.

6

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Page Guide Dutilisation Manual DE Instrucciones English Dual Control Gallon Portable Specifications Risk of Explosion or Fire Safety InstructionsAIR Tank HOT Surfaces Risk from Flying ObjectsRisk to Breathing Risk from Moving PartsGrounding Instructions Risk of Electrical ShockRisk from Noise Inspection of Compressor FeaturesIntroduction Common Procedures Units with a Dual Voltage Switch Units Without a Dual Voltage SwitchChecking Compressor Pump OIL Level Pilot Valve CUT-OUT Pressure AdjustmentDisconnecting Hoses Checking Safety Relief Valve OperationAdjusting Regulator Installing HosesLocation Preparation For UseCompatibility Condensate Discharge Piping Operating ProceduresPre-Start Checklist Air Inlet Filter General RequirementsSHUT-DOWN MaintenanceMaintenance Chart ProcedureChecking Belt Tension AccessoriesAdjusting Belt Tension Repairs Service InformationFull One Year Warranty Problem Code Troubleshooting GuideCode Possible Cause Possible Solution English Français BITENSION/DOUBLE Commande Compresseur Portatif DE 17 Gallons Caractéristiques Techniques Réservoir D’AIR AccessoiresConsignes de sécurité Risques Associés AUX Pièces Mobiles Risque Dexplosion OU DincendieRisques Associés AUX Objets Projetés EN Lair Risques Entraînés PAR LA Respiration DE Lair CompriméRisque DE Choc Électrique Diagramme DES RallongesSurfaces Chaudes Directives DE Mise À LA Terre Bitension Double CommandeInspection du compresseur ComposantsProcédures courantes fonctionnement à 230 volts D55390, D55395, D55570, D55575, D55580, D55585 Exigences Concernant LE MoteurAppareils Munis D’UN Interrupteur Bitension Consulter les surfaces chaudes identifiées à la Réglage DE LA Pression DifférentielleVérification DU Niveau Dhuile DE LA Pompe À Compression Mise EN Marche DE L’APPAREIL Installation DES BoyauxVérification DU Fonctionnement DE LA Soupape DE Sûreté Vérification DE L’ÉLÉMENT DU Filtre À AIRRéglage Initial Préparations avant utilisationDésaccouplement DES Boyaux Purge DES RéservoirsConditions DE Bruit EmplacementEnvironnements Humides ÉlectricitéListe DE Vérification DE PRÉ-DÉMARRAGE Mode d’emploiExigences Générales Conduite DE Vidange DE CondensatEntretien Jour Sem Mois 200 hrs Programme de maintenanceEntretien ArrêtVérification DE LA Tension DE LA Courroie AccessoiresRéglage de la tension de la courroie Garantie complète d’un an ServiceRéparations Problème Code de problème Guide de DépannageCode Cause possible Solution possible Français Español Control Doble Galones Portátil Doble VOLTAJE/DOBLE Control 17 Galones Portátil Dispositivos Y Accesorios Instrucciones de seguridadTanque DE Aire Riesgo DE Piezas Móviles Riesgo DE Explosión O IncendioRiesgo POR Objetos Voladores Riesgo RespiratorioInstrucciones DE Aterrizaje Superficies CalientesRiesgo DE Choque Eléctrico Longitud del cable en metrosRepare O Reemplace LOS Cables Dañados Inmediatamente IntroducciónInspección del compresor CaracterísticasInterruptor DE Presión Voltaje DobleVálvula Piloto Seguro ManualProcedimientos comunes Unidades CON Interruptor DE Voltaje Doble Revisión DE LA Válvula DE Alivio DE Seguridad Ajuste DEL Diferencial DE Presión DE LA Válvula PilotoRevisión DEL Nivel DE Aceite EN LA Bomba DEL Compresor Ajuste DEL Regulador Revisión DEL Elemento DEL Filtro DE AireEncendido DE LA Unidad Apagado DE LA UnidadLocalización Preparación para el usoCompatibilidad Procedimientos de operación Filtro de entrada de aireRequerimientos generales Apagado MantenimientoPara Unidades CON Bomba G Tabla de mantenimientoCambio DE Aceite DE LA Bomba DEL Compresor Revisión DE LA Tensión DE LA BandaAjuste DE LA Tensión DE LA Banda AccesoriosReparaciones Garantía Limitada por un Año a partir de la fecha de compraEspañol Problema Código del problema Guía para solución de problemas frecuentesCódigo Posible causa Posible solución Español

D55170 specifications

The Epson D55170 is a versatile and high-performance printer designed to meet the demanding needs of small to medium-sized businesses. This printer stands out due to its advanced features, innovative technologies, and commitment to delivering exceptional print quality.

One of the key highlights of the D55170 is its PrecisionCore technology, which utilizes an advanced inkjet printing process that produces sharp, detailed images and vibrant colors. This technology features high-density nozzles that can precisely control the placement of ink droplets, resulting in smoother gradations and better color accuracy. The D55170 can print in a variety of formats, from standard letter sizes to larger media, making it suitable for a diverse range of business applications.

Another significant feature of the D55170 is its impressive print speed. This printer can achieve speeds of up to 20 pages per minute for black and white documents and around 10 pages per minute for color prints, enabling businesses to handle large print jobs efficiently. With a first page out time of just a few seconds, the D55170 minimizes waiting times and enhances productivity in busy office environments.

The D55170 is also equipped with a high-capacity ink system, which allows for fewer replacements and more consistent output. The printer supports both standard and high-yield cartridges, giving users the flexibility to choose an option that best fits their printing volume. This feature not only reduces overall printing costs but also minimizes downtime.

In terms of connectivity, the Epson D55170 provides a wide array of options. It supports USB, Ethernet, and wireless connections, making it easy to integrate into any office setup. Mobile printing capabilities allow users to print directly from smartphones and tablets through apps such as Epson iPrint, Apple AirPrint, and Google Cloud Print, further enhancing convenience.

Additionally, the D55170 boasts a user-friendly interface with an intuitive control panel, making navigation simple for users of all skill levels. This printer includes features like automatic duplex printing, leading to substantial paper savings and reduced environmental impact.

In summary, the Epson D55170 is a robust and efficient printing solution built to support varying business needs. With its PrecisionCore technology, impressive print speeds, high-capacity ink system, and versatile connectivity options, this printer is an excellent choice for businesses looking to achieve high-quality prints while maintaining productivity and cost-effectiveness.
Top Page Image Contents