Epson D55170 Air Inlet Filter General Requirements, Operating Procedures, Pre-Start Checklist

Page 15

English

horizontal surface. Use care when driving so to avoid tipping the unit over in the vehicle. Damage can occur to the unit or surrounding items if unit is tipped. Use a ramp if loading or unloading the unit from a height of more than 12".

ALWAYS STORE COMPRESSOR IN A HORIZONTAL POSITION, ON ALL FOUR RUBBER MOUNTS.

MOVING:

When moving the unit into a position for use, grasp handle grips at rear of compressor, and lift compressor high enough so unit can be rolled on the front tire.

WARNING: Ensure proper footing and use caution when rolling compressor so that unit does not tip or cause loss of balance.

When location is reached slowly lower rear of compressor to ground.

Air Inlet Filter

CAUTION: Do not operate without air inlet filter

General Requirements

The piping, fittings, receiver tank, etc. must be certified safe for at least the maximum working pressure of the unit. Use hard welded or threaded steel or copper pipes, cast iron fittings and hoses that are certified safe for the unit ís discharge pressure and temperature. Use pipe thread sealant on all threads, and tighten joints thoroughly to prevent air leaks. DO NOT USE PVC PLASTIC.

CONDENSATE DISCHARGE PIPING

If installing a condensate discharge line, the piping must be at least one size larger than the connection, as short and direct as possible, secured tightly and routed to a suitable drain point. Condensate must be disposed of in accordance with local, state and federal laws and regulations.

NOTE: All compressed air systems generate condensate that accumulates in any drain point (e.g. tanks, filter, aftercoolers, dryers). This condensate contains lubricating oil and/or substances which may be regulated and must be disposed of in accordance with local, state, and federal laws and regulations.

Operating Procedures

Pre-Start Checklist

1.Ensure the ON/OFF lever switch is in the OFF position.

2.Ensure tank(s) is/are drained so that moisture, dirt, etc. can be eliminated.

3.Ensure tank pressure gauge reads 0 psi.

4.Ensure safety and drain valve(s) is/are functioning properly.

5.Ensure the drain valve(s) is/are closed.

6.Check oil level in pump.

7.Visually inspect drive belt. Replace belt if frayed, cracked, or worn.

8.Ensure all guards, covers, and labels are in place, legible (for labels) and securely mounted. Do not use compressor until all items have been verified.

START-UP

1.Ensure the ON/OFF lever is in the OFF position.

2.Pull out and turn regulator knob counterclockwise until fully closed. Push in to lock. Regulated pressure gage should read 0 psi.

3.Plug cord into a grounded wall outlet.

WARNING: Make sure that the correct cord plug end is properly connected to the compressor cordset before operating in 115 or 230 volt mode.

NOTE: For dual control units, ensure the pilot valve is adjusted to the desired setting (see the Dual Control section in the Common Procedures).

4.For D55170 and D55180 Only, Rotate manual lock on pilot valve to an in-line position

5.Turn the ON/OFF lever to the ON position.

6.For D55170 and D55180 Only: Rotate manual lock on pilot valve to a perpendicular position so pump will charge tanks.

7.Allow compressor to pump up to “cut out” pressure.

10

Image 15
Contents Page Guide Dutilisation Manual DE Instrucciones English Dual Control Gallon Portable Specifications Safety Instructions AIR TankRisk of Explosion or Fire HOT Surfaces Risk from Flying ObjectsRisk to Breathing Risk from Moving PartsRisk of Electrical Shock Risk from NoiseGrounding Instructions Features IntroductionInspection of Compressor Common Procedures Units with a Dual Voltage Switch Units Without a Dual Voltage SwitchChecking Compressor Pump OIL Level Pilot Valve CUT-OUT Pressure AdjustmentDisconnecting Hoses Checking Safety Relief Valve OperationAdjusting Regulator Installing HosesPreparation For Use CompatibilityLocation Condensate Discharge Piping Operating ProceduresPre-Start Checklist Air Inlet Filter General RequirementsSHUT-DOWN MaintenanceMaintenance Chart ProcedureAccessories Adjusting Belt TensionChecking Belt Tension Service Information Full One Year WarrantyRepairs Problem Code Troubleshooting GuideCode Possible Cause Possible Solution English Français BITENSION/DOUBLE Commande Compresseur Portatif DE 17 Gallons Caractéristiques Techniques Accessoires Consignes de sécuritéRéservoir D’AIR Risques Associés AUX Pièces Mobiles Risque Dexplosion OU DincendieRisques Associés AUX Objets Projetés EN Lair Risques Entraînés PAR LA Respiration DE Lair CompriméDiagramme DES Rallonges Surfaces ChaudesRisque DE Choc Électrique Directives DE Mise À LA Terre Bitension Double CommandeInspection du compresseur ComposantsProcédures courantes fonctionnement à 230 volts Exigences Concernant LE Moteur Appareils Munis D’UN Interrupteur BitensionD55390, D55395, D55570, D55575, D55580, D55585 Réglage DE LA Pression Différentielle Vérification DU Niveau Dhuile DE LA Pompe À CompressionConsulter les surfaces chaudes identifiées à la Mise EN Marche DE L’APPAREIL Installation DES BoyauxVérification DU Fonctionnement DE LA Soupape DE Sûreté Vérification DE L’ÉLÉMENT DU Filtre À AIRRéglage Initial Préparations avant utilisationDésaccouplement DES Boyaux Purge DES RéservoirsConditions DE Bruit EmplacementEnvironnements Humides ÉlectricitéListe DE Vérification DE PRÉ-DÉMARRAGE Mode d’emploiExigences Générales Conduite DE Vidange DE CondensatEntretien Jour Sem Mois 200 hrs Programme de maintenanceEntretien ArrêtAccessoires Réglage de la tension de la courroieVérification DE LA Tension DE LA Courroie Service RéparationsGarantie complète d’un an Problème Code de problème Guide de DépannageCode Cause possible Solution possible Français Español Control Doble Galones Portátil Doble VOLTAJE/DOBLE Control 17 Galones Portátil Instrucciones de seguridad Tanque DE AireDispositivos Y Accesorios Riesgo DE Piezas Móviles Riesgo DE Explosión O IncendioRiesgo POR Objetos Voladores Riesgo RespiratorioInstrucciones DE Aterrizaje Superficies CalientesRiesgo DE Choque Eléctrico Longitud del cable en metrosRepare O Reemplace LOS Cables Dañados Inmediatamente IntroducciónInspección del compresor CaracterísticasInterruptor DE Presión Voltaje DobleVálvula Piloto Seguro ManualProcedimientos comunes Unidades CON Interruptor DE Voltaje Doble Ajuste DEL Diferencial DE Presión DE LA Válvula Piloto Revisión DEL Nivel DE Aceite EN LA Bomba DEL CompresorRevisión DE LA Válvula DE Alivio DE Seguridad Ajuste DEL Regulador Revisión DEL Elemento DEL Filtro DE AireEncendido DE LA Unidad Apagado DE LA UnidadPreparación para el uso CompatibilidadLocalización Filtro de entrada de aire Requerimientos generalesProcedimientos de operación Apagado MantenimientoPara Unidades CON Bomba G Tabla de mantenimientoCambio DE Aceite DE LA Bomba DEL Compresor Revisión DE LA Tensión DE LA BandaAjuste DE LA Tensión DE LA Banda AccesoriosReparaciones Garantía Limitada por un Año a partir de la fecha de compraEspañol Problema Código del problema Guía para solución de problemas frecuentesCódigo Posible causa Posible solución Español

D55170 specifications

The Epson D55170 is a versatile and high-performance printer designed to meet the demanding needs of small to medium-sized businesses. This printer stands out due to its advanced features, innovative technologies, and commitment to delivering exceptional print quality.

One of the key highlights of the D55170 is its PrecisionCore technology, which utilizes an advanced inkjet printing process that produces sharp, detailed images and vibrant colors. This technology features high-density nozzles that can precisely control the placement of ink droplets, resulting in smoother gradations and better color accuracy. The D55170 can print in a variety of formats, from standard letter sizes to larger media, making it suitable for a diverse range of business applications.

Another significant feature of the D55170 is its impressive print speed. This printer can achieve speeds of up to 20 pages per minute for black and white documents and around 10 pages per minute for color prints, enabling businesses to handle large print jobs efficiently. With a first page out time of just a few seconds, the D55170 minimizes waiting times and enhances productivity in busy office environments.

The D55170 is also equipped with a high-capacity ink system, which allows for fewer replacements and more consistent output. The printer supports both standard and high-yield cartridges, giving users the flexibility to choose an option that best fits their printing volume. This feature not only reduces overall printing costs but also minimizes downtime.

In terms of connectivity, the Epson D55170 provides a wide array of options. It supports USB, Ethernet, and wireless connections, making it easy to integrate into any office setup. Mobile printing capabilities allow users to print directly from smartphones and tablets through apps such as Epson iPrint, Apple AirPrint, and Google Cloud Print, further enhancing convenience.

Additionally, the D55170 boasts a user-friendly interface with an intuitive control panel, making navigation simple for users of all skill levels. This printer includes features like automatic duplex printing, leading to substantial paper savings and reduced environmental impact.

In summary, the Epson D55170 is a robust and efficient printing solution built to support varying business needs. With its PrecisionCore technology, impressive print speeds, high-capacity ink system, and versatile connectivity options, this printer is an excellent choice for businesses looking to achieve high-quality prints while maintaining productivity and cost-effectiveness.