Epson D55170 manual Risk of Electrical Shock, Risk from Noise, Grounding Instructions

Page 8

compressor during or immediately after operation. Compressor will remain hot for several minutes after operation. Do not move the compressor while it is running. Hot motor parts could cause burns contributing to the dropping of the compressor, damaging the compressor and/or injuring the operator.

RISK OF ELECTRICAL SHOCK

Your air compressor is powered by electricity, if it is not used properly it could cause electric shock. Never operate the compressor out-doors when it is raining or in wet conditions.

Never operate compressor with guards or protective

covers that are damaged or removed. Repairs by anyone other than qualified personnel can result in serous injury or death by electrocution. Any electrical wiring or repairs required on this product should be performed by authorized service personnel in accordance with national and local electrical codes.

REPAIR OR REPLACE DAMAGED OR WORN CORDS IMMEDIATELY.

THE USE OF A GFCI OUTLET IS RECOMMENDED AND MAY BE REQUIRED IN CERTAIN AREAS

RISK FROM NOISE

CAUTION: Wear appropriate personal hearing protection during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss.

Extension Cord Chart

 

1.5 Hp Motor

 

 

 

 

Rating

Length of Cord in Feet

 

 

25’

50’

100’

 

16 amp, 115V

14 Ga.

12 Ga.

10 Ga.

8 amp, 230V

16 Ga.

16 Ga.

14 Ga.

2 Hp Motor

 

 

 

Rating

Length of Cord in Feet

 

 

25’

50’

100’

 

20 amp, 115V

14 Ga.

12 Ga.

8 Ga.

9 amp, 230V

16 Ga.

16 Ga.

14 Ga.

DEWALT does not recommend the use of extension cords as this can create power loss and overheating of the motor. Use of an additional air hose is recommended rather than the extension cord. If use of an extension cord is unavoidable, it should be plugged into a GFCI found in circuit boxes or protected receptacles. When using an extension cord, observe the following.

GROUNDING INSTRUCTIONS

In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This tool is equipped with an electric cord having an equipment- grounding conductor and grounding plug. The plug must be plugged into a matching outlet that is properly installed and grounded in accordance with all local codes and ordinances. Make sure that the electrical circuit to which the compressor is connected provides proper electrical grounding, correct voltage and adequate fuse protection. Do not modify plug provided: if it will not fit the outlet, have the proper outlet installed by a qualified electrician.

Improper connection of the equipment-grounding conductor can result in a risk of electric shock. The conductor with insulation having an outer surface that is green with or without yellow stripes is the equipment- grounding conductor. If repair or replacement of the electric cord or plug is necessary do not connect the equipment-grounding conductor to a live terminal.

Check with a qualified electrician or service personnel if the grounding instructions are not completely understood or if in doubt as to whether the tool is properly grounded.

Use only 3-wire extension cords that have 3-prong grounding plugs and 3-pole receptacles.

Grounded tools intended for use on a supply circuit having a nominal rating less than 150 volts: This tool is intended for use on a circuit that has an outlet that looks like the one illustrated in Figure A.The tool has a grounding plug that looks like the plug illustrated in Figure A. temporary adapter, which looks like the adapter illustrated in Figures B and C, may be used to connect this plug to a 2-pole receptacle as

English

3

Image 8
Contents Page Guide Dutilisation Manual DE Instrucciones English Dual Control Gallon Portable Specifications Risk of Explosion or Fire Safety InstructionsAIR Tank Risk from Flying Objects Risk to BreathingRisk from Moving Parts HOT SurfacesGrounding Instructions Risk of Electrical ShockRisk from Noise Inspection of Compressor FeaturesIntroduction Common Procedures Units Without a Dual Voltage Switch Units with a Dual Voltage SwitchPilot Valve CUT-OUT Pressure Adjustment Checking Compressor Pump OIL LevelChecking Safety Relief Valve Operation Adjusting RegulatorInstalling Hoses Disconnecting HosesLocation Preparation For UseCompatibility Operating Procedures Pre-Start ChecklistAir Inlet Filter General Requirements Condensate Discharge PipingMaintenance Maintenance ChartProcedure SHUT-DOWNChecking Belt Tension AccessoriesAdjusting Belt Tension Repairs Service InformationFull One Year Warranty Troubleshooting Guide Problem CodeCode Possible Cause Possible Solution English Français BITENSION/DOUBLE Commande Compresseur Portatif DE 17 Gallons Caractéristiques Techniques Réservoir D’AIR AccessoiresConsignes de sécurité Risque Dexplosion OU Dincendie Risques Associés AUX Objets Projetés EN LairRisques Entraînés PAR LA Respiration DE Lair Comprimé Risques Associés AUX Pièces MobilesRisque DE Choc Électrique Diagramme DES RallongesSurfaces Chaudes Directives DE Mise À LA Terre Double Commande Inspection du compresseurComposants BitensionProcédures courantes fonctionnement à 230 volts D55390, D55395, D55570, D55575, D55580, D55585 Exigences Concernant LE MoteurAppareils Munis D’UN Interrupteur Bitension Consulter les surfaces chaudes identifiées à la Réglage DE LA Pression DifférentielleVérification DU Niveau Dhuile DE LA Pompe À Compression Installation DES Boyaux Vérification DU Fonctionnement DE LA Soupape DE SûretéVérification DE L’ÉLÉMENT DU Filtre À AIR Mise EN Marche DE L’APPAREILPréparations avant utilisation Désaccouplement DES BoyauxPurge DES Réservoirs Réglage InitialEmplacement Environnements HumidesÉlectricité Conditions DE BruitMode d’emploi Exigences GénéralesConduite DE Vidange DE Condensat Liste DE Vérification DE PRÉ-DÉMARRAGEProgramme de maintenance EntretienArrêt Entretien Jour Sem Mois 200 hrsVérification DE LA Tension DE LA Courroie AccessoiresRéglage de la tension de la courroie Garantie complète d’un an ServiceRéparations Guide de Dépannage Problème Code de problèmeCode Cause possible Solution possible Français Español Control Doble Galones Portátil Doble VOLTAJE/DOBLE Control 17 Galones Portátil Dispositivos Y Accesorios Instrucciones de seguridadTanque DE Aire Riesgo DE Explosión O Incendio Riesgo POR Objetos VoladoresRiesgo Respiratorio Riesgo DE Piezas MóvilesSuperficies Calientes Riesgo DE Choque EléctricoLongitud del cable en metros Instrucciones DE AterrizajeIntroducción Inspección del compresorCaracterísticas Repare O Reemplace LOS Cables Dañados InmediatamenteVoltaje Doble Válvula PilotoSeguro Manual Interruptor DE PresiónProcedimientos comunes Unidades CON Interruptor DE Voltaje Doble Revisión DE LA Válvula DE Alivio DE Seguridad Ajuste DEL Diferencial DE Presión DE LA Válvula PilotoRevisión DEL Nivel DE Aceite EN LA Bomba DEL Compresor Revisión DEL Elemento DEL Filtro DE Aire Encendido DE LA UnidadApagado DE LA Unidad Ajuste DEL ReguladorLocalización Preparación para el usoCompatibilidad Procedimientos de operación Filtro de entrada de aireRequerimientos generales Mantenimiento ApagadoTabla de mantenimiento Cambio DE Aceite DE LA Bomba DEL CompresorRevisión DE LA Tensión DE LA Banda Para Unidades CON Bomba GAccesorios ReparacionesGarantía Limitada por un Año a partir de la fecha de compra Ajuste DE LA Tensión DE LA BandaEspañol Guía para solución de problemas frecuentes Problema Código del problemaCódigo Posible causa Posible solución Español

D55170 specifications

The Epson D55170 is a versatile and high-performance printer designed to meet the demanding needs of small to medium-sized businesses. This printer stands out due to its advanced features, innovative technologies, and commitment to delivering exceptional print quality.

One of the key highlights of the D55170 is its PrecisionCore technology, which utilizes an advanced inkjet printing process that produces sharp, detailed images and vibrant colors. This technology features high-density nozzles that can precisely control the placement of ink droplets, resulting in smoother gradations and better color accuracy. The D55170 can print in a variety of formats, from standard letter sizes to larger media, making it suitable for a diverse range of business applications.

Another significant feature of the D55170 is its impressive print speed. This printer can achieve speeds of up to 20 pages per minute for black and white documents and around 10 pages per minute for color prints, enabling businesses to handle large print jobs efficiently. With a first page out time of just a few seconds, the D55170 minimizes waiting times and enhances productivity in busy office environments.

The D55170 is also equipped with a high-capacity ink system, which allows for fewer replacements and more consistent output. The printer supports both standard and high-yield cartridges, giving users the flexibility to choose an option that best fits their printing volume. This feature not only reduces overall printing costs but also minimizes downtime.

In terms of connectivity, the Epson D55170 provides a wide array of options. It supports USB, Ethernet, and wireless connections, making it easy to integrate into any office setup. Mobile printing capabilities allow users to print directly from smartphones and tablets through apps such as Epson iPrint, Apple AirPrint, and Google Cloud Print, further enhancing convenience.

Additionally, the D55170 boasts a user-friendly interface with an intuitive control panel, making navigation simple for users of all skill levels. This printer includes features like automatic duplex printing, leading to substantial paper savings and reduced environmental impact.

In summary, the Epson D55170 is a robust and efficient printing solution built to support varying business needs. With its PrecisionCore technology, impressive print speeds, high-capacity ink system, and versatile connectivity options, this printer is an excellent choice for businesses looking to achieve high-quality prints while maintaining productivity and cost-effectiveness.