Epson D55170 manual Shut-Down, Maintenance Chart, Procedure, Day Week Month 200 Hrs

Page 16

NOTE: For constant run operation or units: after the compressor reaches cut-out pressure the unit will continue to run but will not charge air. A slight air noise may be heard which is the unloading of the air through the pump head. For Stop/Start units: after the compressor reaches cut-out pressure the unit will turn off and a slight air noise will be heard which is the unloading of the head through the pressure switch. If unit does not stop, refer to the Dual Control section in the Common Procedures section.

NOTE: If any unusual noise or vibration is noticed, stop the compressor and refer to the troubleshooting section.

8.Attach hose and accessory.

9.Adjust regulator to desired setting.

SHUT-DOWN

NOTE: Never stop the air compressor by unplugging it from the power source. This could result in damage to the unit.

1. Move the ON/OFF lever to the OFF position.

NOTE: If finished using compressor, follow steps 2 - 7 below.

2.Unplug cord from wall outlet.

3.Turn regulator knob counterclockwise until fully closed. Ensure regulated pressure gage reads 0 PSI.

4.Remove hose and accessory.

5.Drain the air tank(s).

6.Allow the compressor to cool down.

7.Wipe air compressor clean and store in a safe, non freezing area.

Maintenance

The following procedures must be followed when maintenance or service is performed on the air compressor.

1.Turn off air compressor

2.Disconnect cord from electrical outlet

3.Drain tank(s)

4.Allow air compressor to cool down before starting service

NOTE: All compressed air systems contain maintenance parts (e.g. lubricating oil, filters, separators) that are periodically replaced. These used parts may contain, substances that are regulated and must be disposed of in accordance with local, state, and federal laws and regulations.

NOTE: Take note of the positions and locations of parts during disassembly to make reassembly easier.

NOTE: Any service operations not included in this section should be performed by authorized service personnel.

MAINTENANCE CHART

 

Procedure

1 Year or

 

Day Week Month 200 Hrs.

Check pump oil level

X

Oil leak inspection

X

Drain condensation in air tank(s)

X

Check for unusual noise/vibration

X

Check for air leaks*

X

Inspect belt

X

Inspect air filter

X

Clean exterior of compressor

X

Check safety relief valve

X

Check belt adjustment

X

Change pump oil **

X

*To check for air leaks apply a solution of soapy water around joints. While compressor is pumping to pressure and after pressure cuts out look for air bubbles.

**The pump oil must be changed after the first 20 hours of operation. Thereafter, when using DEWALT synthetic oil, change oil every 200 hours of operation or once a year, whichever comes first. In harsh environments, maintenance must be performed on a more accelerated schedule.

English

11

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Page Guide Dutilisation Manual DE Instrucciones English Dual Control Gallon Portable Specifications AIR Tank Safety InstructionsRisk of Explosion or Fire Risk from Flying Objects Risk to BreathingRisk from Moving Parts HOT SurfacesRisk from Noise Risk of Electrical ShockGrounding Instructions Introduction FeaturesInspection of Compressor Common Procedures Units Without a Dual Voltage Switch Units with a Dual Voltage SwitchPilot Valve CUT-OUT Pressure Adjustment Checking Compressor Pump OIL LevelChecking Safety Relief Valve Operation Adjusting RegulatorInstalling Hoses Disconnecting HosesCompatibility Preparation For UseLocation Operating Procedures Pre-Start ChecklistAir Inlet Filter General Requirements Condensate Discharge PipingMaintenance Maintenance ChartProcedure SHUT-DOWNAdjusting Belt Tension AccessoriesChecking Belt Tension Full One Year Warranty Service InformationRepairs Troubleshooting Guide Problem CodeCode Possible Cause Possible Solution English Français BITENSION/DOUBLE Commande Compresseur Portatif DE 17 Gallons Caractéristiques Techniques Consignes de sécurité AccessoiresRéservoir D’AIR Risque Dexplosion OU Dincendie Risques Associés AUX Objets Projetés EN LairRisques Entraînés PAR LA Respiration DE Lair Comprimé Risques Associés AUX Pièces MobilesSurfaces Chaudes Diagramme DES RallongesRisque DE Choc Électrique Directives DE Mise À LA Terre Double Commande Inspection du compresseurComposants BitensionProcédures courantes fonctionnement à 230 volts Appareils Munis D’UN Interrupteur Bitension Exigences Concernant LE MoteurD55390, D55395, D55570, D55575, D55580, D55585 Vérification DU Niveau Dhuile DE LA Pompe À Compression Réglage DE LA Pression DifférentielleConsulter les surfaces chaudes identifiées à la Installation DES Boyaux Vérification DU Fonctionnement DE LA Soupape DE SûretéVérification DE L’ÉLÉMENT DU Filtre À AIR Mise EN Marche DE L’APPAREILPréparations avant utilisation Désaccouplement DES BoyauxPurge DES Réservoirs Réglage InitialEmplacement Environnements HumidesÉlectricité Conditions DE BruitMode d’emploi Exigences GénéralesConduite DE Vidange DE Condensat Liste DE Vérification DE PRÉ-DÉMARRAGEProgramme de maintenance EntretienArrêt Entretien Jour Sem Mois 200 hrsRéglage de la tension de la courroie AccessoiresVérification DE LA Tension DE LA Courroie Réparations ServiceGarantie complète d’un an Guide de Dépannage Problème Code de problèmeCode Cause possible Solution possible Français Español Control Doble Galones Portátil Doble VOLTAJE/DOBLE Control 17 Galones Portátil Tanque DE Aire Instrucciones de seguridadDispositivos Y Accesorios Riesgo DE Explosión O Incendio Riesgo POR Objetos VoladoresRiesgo Respiratorio Riesgo DE Piezas MóvilesSuperficies Calientes Riesgo DE Choque EléctricoLongitud del cable en metros Instrucciones DE AterrizajeIntroducción Inspección del compresorCaracterísticas Repare O Reemplace LOS Cables Dañados InmediatamenteVoltaje Doble Válvula PilotoSeguro Manual Interruptor DE PresiónProcedimientos comunes Unidades CON Interruptor DE Voltaje Doble Revisión DEL Nivel DE Aceite EN LA Bomba DEL Compresor Ajuste DEL Diferencial DE Presión DE LA Válvula PilotoRevisión DE LA Válvula DE Alivio DE Seguridad Revisión DEL Elemento DEL Filtro DE Aire Encendido DE LA UnidadApagado DE LA Unidad Ajuste DEL ReguladorCompatibilidad Preparación para el usoLocalización Requerimientos generales Filtro de entrada de aireProcedimientos de operación Mantenimiento ApagadoTabla de mantenimiento Cambio DE Aceite DE LA Bomba DEL CompresorRevisión DE LA Tensión DE LA Banda Para Unidades CON Bomba GAccesorios ReparacionesGarantía Limitada por un Año a partir de la fecha de compra Ajuste DE LA Tensión DE LA BandaEspañol Guía para solución de problemas frecuentes Problema Código del problemaCódigo Posible causa Posible solución Español

D55170 specifications

The Epson D55170 is a versatile and high-performance printer designed to meet the demanding needs of small to medium-sized businesses. This printer stands out due to its advanced features, innovative technologies, and commitment to delivering exceptional print quality.

One of the key highlights of the D55170 is its PrecisionCore technology, which utilizes an advanced inkjet printing process that produces sharp, detailed images and vibrant colors. This technology features high-density nozzles that can precisely control the placement of ink droplets, resulting in smoother gradations and better color accuracy. The D55170 can print in a variety of formats, from standard letter sizes to larger media, making it suitable for a diverse range of business applications.

Another significant feature of the D55170 is its impressive print speed. This printer can achieve speeds of up to 20 pages per minute for black and white documents and around 10 pages per minute for color prints, enabling businesses to handle large print jobs efficiently. With a first page out time of just a few seconds, the D55170 minimizes waiting times and enhances productivity in busy office environments.

The D55170 is also equipped with a high-capacity ink system, which allows for fewer replacements and more consistent output. The printer supports both standard and high-yield cartridges, giving users the flexibility to choose an option that best fits their printing volume. This feature not only reduces overall printing costs but also minimizes downtime.

In terms of connectivity, the Epson D55170 provides a wide array of options. It supports USB, Ethernet, and wireless connections, making it easy to integrate into any office setup. Mobile printing capabilities allow users to print directly from smartphones and tablets through apps such as Epson iPrint, Apple AirPrint, and Google Cloud Print, further enhancing convenience.

Additionally, the D55170 boasts a user-friendly interface with an intuitive control panel, making navigation simple for users of all skill levels. This printer includes features like automatic duplex printing, leading to substantial paper savings and reduced environmental impact.

In summary, the Epson D55170 is a robust and efficient printing solution built to support varying business needs. With its PrecisionCore technology, impressive print speeds, high-capacity ink system, and versatile connectivity options, this printer is an excellent choice for businesses looking to achieve high-quality prints while maintaining productivity and cost-effectiveness.
Top Page Image Contents