Sears 113.298141 owner manual Blade TILT, or Squareness Blade to Table, Space

6. If

tooth

does

not touch

the same

amount

...

the

mechanism

underneath

must

be adjusted to

make

the

blade PARALLEL

to

GROOVE.

A.

Rear

trunnion

must

be

moved

TOWARD

the

combination

square

if

there

is

a space

between

marked

tooth

and

end

of

square

in step 4,

B,

Rear trunnion

must

be

moved

AWAY

from

the

square

if

marked

tooth

pushes

square

out

of

position

in

the

groove.

7.Loosen all three screws that hold the rear trunnion and all three screws that hold the front trunmon.

NOTE: All six screws can be reached through back of saw. Use a 9/16-in. wrench, To reach left-hand front trunnion

screw, tilt blade to 45 °. After loosening screws reposition blade at 90 ° .

Using a wood block and mallet as shown, move rear trunnion to right or left as required to realign the blade. If necessary, shift front trunnion in similar manner; but do NOT move front trunnion unless necessary. Recheck

the alignment w th the square, then secure y ret ghten all six trunmon screws.

BLADE TILT, OR SQUARENESS

OF BLADE TO TABLE

gO ° (SQUARE) and 45 ° (BEVEL) STOP COLLARS.

When the bevel oointer is pointing directly to the "0" mark on the bevel scale, the sawblade should make a SQUARE cut 90 ° to the table.

To check for SQUAR EN ESS:

WARNING: FOR YOUR OWN SAFETY, TURN SWITCH

"OFF" AND REMOVE PLUG FROM POWER SOURCE

OUTLET.

1.Raise blade all the way UP... raise blade guard

2.Place the square against blade. Make sure square is not touching the TIP of one of the saw TEETH.

FRONT TRUNNION REAR TRUNNION

REAR-TRUNNION

SCREWS

/ l

FRONT-TRUNNION SCREWS

EDGE OF TRUNNION

OCK

_1

'PLACEBLOCK HERE

--OR HERE

EDGE OF

REAR OF SAW

CRADLE

3O