Sears 113.298141 owner manual Installing Blade Guard, Hex, HEX HD. Screws, Do not Tighten

INSTALLING BLADE GUARD

1.From among the loose parts, find

2	Hex Head Screws, 1/4 - 20 x 5/8 in. long
2	Hex Head Screws, 5/16	- 18 x 5/8 in. long
2	Hex Head Screws, 5/16	- 18 x	1 in. long	GUARD		SUPPORT
2	Hex Nuts, 1/4 - 20
				5/16-18		X
	(approx. dia. of hole 1/4 in.)
2	Lockwashers, 1/4 in, External		Type	5/8	iN.
				HEX
	(approx. dia. of hole 1/4 in.)
				SCREW
2	Lockwashers, 5/16 in. External		Type
	(approx, dia. of hole 5/16 in.}
1 Thumbscrew
Guard Support								CRADLE
Spreader Support				5/16-18		X	t IN.
Spreader Rod				HEX	HD.		SCREW
2. Lower the blade.								5f16-1Bk5/8.
3. Screw the two MOTOR BASE CLAMP SCREWS part
								HEX HD. SCREWS
way into cradle.
4. Attach GUARD SUPPORT..,			DO NOT TIGHTEN
screws.

Insert SPREADER ROD into SPREADER SUPPORT until pin fits into notch, Insert Thumbscrew and tighten

it

THUMB SCREW •

SPREADER

ROD

\

FLAT

SURFACE

(INTO SUPPORT)

II

SPREADER

SUPPORT

u

6. Slide SPREADER ROD into GUARD SUPPORT until

left end of ROD extends approximately 1/, inch beyond

edge of SUPPORT... Snug up Hex Head Screw in

SUPPORT.

7. Attach SPREADER to SPREADER SUPPORT so that screws are all the way back in the SLOTS of SUPPORT

_ __tighten screws.

8.Raise ANTIKICKBACK PAWL (hold it in place with a piece of masking tape)

•.. align spreader SQUARE to table

NOTE: The framing {or combination) square must be "true" -- see start of "assembly and alignment" section on page 6 for checking method,

... Tighten both 5/16-18 x 1 in. HEX HEAD SCREWS.

1/4-20 HEX

HD. SCREW 1/41N. LOCKWASHEI

1/4-20 flEX NUT

END OF ROD

I/4 INCH TO LEF

OF EDGE OF

SUPPORT

GUARD

SUPPOR'

j			-18 x I IN.
SCREWS	ALL	HEX	HD. SCREWS
		THE	I	t
BACK	IN	SLOTS	[

IN SUPPORT

14