To remove insert.
A)Loosen Screw
B)Lift insert from front end, and pull toward front of
saw,
4.To replace insert.
Place insert into insert opening in table and push toward rear of saw to engage spring clip and until keyslot in insert will drop over screw. Tighten screw.
Do not tighten screw to the point where it will deflect the insert.
CHECKING BLADE SQUARENESS TO TABLE
IMPORTANT: BLADE must be SQUARE (g0 °) to TABLE, in order to proceed with assembly.
To check for blade squareness, refer to "BLADE TILT, OR SQUARENESS OF BLADE TO TABLE" adjustment on page 30.
CHECKING BLADE FOR HEEL
IMPORTANT: Saw blade MUST be parallel to miter gauge groove,
To check for parallelism, refer to "HEELING
ADJUSTMENT OR PARALLELISM OF SAWBLADE TO MITER GAUGE GROOVE" adjustment on page 29 and 30.
ASSEMBLING STEEL LEGS
NOTE: Steel Legs are furnished with Model 113.298031 and 113,298151. From among the loose parts, find the following Hardware:
24Truss Head Screws, 1/4 - 20 X 5/8 in. long (top of screw is rounded)
24 Lockwashers, 1/4 in. External Type (approx. dia, of hole 1/4 in.)
24 Hex Nuts, 1/4 - 20 (approx. dia. of hole 1/4 in.) 8 Hex Nuts, 1/2 - 13 (approx. dia. of hole 1/2 in.)
4 Leveling feet.
Assemble the legs as shown .,.
1.Insert the Truss Head Screws through the holes in the legs, then through the holes in the stiffeners. MAKE
SURE THE SCREWS GO THROUGH THE HOLES IN THE SIDE STIFFENERS MARKED "×".
2.Install the Iockwashers ... screw on the nuts but do not tighten until completely assembled.
3.Install leveling feet.
SIDE STIFFENER
END
STIFFENER"
IN. HEX NUTS