Lay REARFENCE GUIDE BAR on table to act as a
straightedge. If outer edge of extension is higher or lower than table surface;
A.Slightly loosen nuts holding bracket to extension using 7/16 in. wrench.
B.Move end of extension up or down until outer edge is even with table surface ... check with GUIDE
BAR .., tighten nuts.
C.Recheck INNER edge of extension to make sure it has not moved ... readjust, if necessary.
INSTALLING RIP FENCE GUIDE BARS AND SWITCH BOX
1.From among the loose parts find the following hardware:
2 Hex. Head Screws,
1 Hex, Head Screw,
5 Hex. Nuts.
2 Flat washers (dia. of hole 21/64 in,I
2 Spacers, 3/4 in. dia. x 1/2 in. long
2
1Fence Guide Bar Rod
2.Lay guide bars on sawtable.
NOTE: The various holes in the bar allow them to be
positioned on this saw and also makes them adaptable to other models.
3.Insert a
another
Insert bolts through holes in middle and on right side of front of saw table ... install Iockwashers and nuts.
DONOr SCREW NUTS ON ALL THE WAY, just get them started on the screws.
/
!
then through the hole at EXTREME LEFT SIDE OF
SWITCH then through SEVENTH hole in bar. Hold them in place with a piece of masking tape ... Insert the 3/4 in. long screw through a flat washer and then through hole at RIGHT SIDE OF SWITCH and then through the EIGHT hole in bar. Install a Iockwasher and nut and tighten.
4.Place spacers on screws.
6= Remove the 3 screws from rear of table extension.
7.Insert 1 in. long screws in SECOND and FOURTH holes of rear bar and attach to table the same way.
Insert ends of FENCE GUIDE BAR ROD through round holes at outer end of bars,
NOTE: The ends of the ROD are not threaded .., the SELF THREADING NUTS will cut threads on the rod as they are screwed on.
\
10