Sears 113.298141 owner manual Position, Accurate, Pointer Does Not

3. Operate the tilt-lock handle (COUNTERCLOCKWISE) to loosen the tilt clamp screw.

4. NOTE: Handle is spring loaded for engagement with screw head - must be pushed inward for disengagement whenever necessary to obtain a new grip on screw head.

5.Rotate tilt handwheel CLOCKWISE a few turns to till blade. Now rotate handwheel COUNTERCLOCKWISE

until it stops. Blade should now be square with table and pointer should point to "0".

If blade is SQUARE to table;

A.Check pointer

F POINTER DOES NOT point to the "O" mark on the bevel scale;

A. Remove Elevation Handwheel.

B. Loosen screw and adjust pointer ... using medium screwdriver.

C. Install Elevation Handwheel.

If blade is NOT SQUARE to table.., the 90 ° LIMIT STOP must be ADJUSTED.

1. Using a medium size screwdriver, loosen BOTH setscrews in 90 ° STOP COLLAR.

NOTE: If you can't reach the setscrews, turn the TILT

NANDWHEEL slightly.

2.ROTATE the STOP COLLAR moving it all the way to the end of TILT SCREW. (to the right).

3.TILT blade RIGHT or LEFT ... checking with your

square until blade is square to table. COLLAR

4.ROTATE STOP COLLAR moving it to the right until it

stops... TIGHTEN the setscrews.

5.Check POINTER. If it DOES NOT point to the "O" mark on the bevel scale...

A. Remove Elevation Handwheel.

B.Loosen screw and ad)ust pointer ... using medium screwdriver.

C.Install Elevation Handwheel.

45 °

POSITION

TILT blade to LEFT as far as it will go. It will stop when

the PIVOT NUT is against the 45 ° STOP COLLAR.

A,

Place

an

ACCURATE

square

against

blade.

Make

sure square is not touching the TIP of one o{ the

saw TEETH.

If blade is 45 ° to table;

A.

Check

pointer.

If

POINTER

DOES

NOT

point

to

the

45 °

mark

on

the

scale;

POINTER points

to 45 ° mark.

A.

Remove

Elevation Handwheel.

B,

Loosen

two

screws

on

scale

and

adjust scale

until

C. Install Elevation

Handwheel.

31