GETTING TO KNOW YOUR SAW
|
| _1 SAWSLADE |
|
| 7" BLADE GUARD |
| TABLEINSERT | |
MITER GAUGE | 0 | ANTIKICKBACK |
| \ | PAWLS |
|
| |
LOCK HANDLE |
|
|
6 MITER GAUGE |
| RiP FENCE |
|
| |
RIP FENCE |
|
|
LOCK HANDLE |
|
|
4TILT LOCK HANDLE (UNDERNEATH TABLE)
2ELEVATION HANDWHEEL
\
1 ON-OFF SWITCH
1
CAUTION: Before turning switch on, make sure the blade guard is correctly installed and operating properly.
The On-Off Switch has a locking feature. THIS FEATURE
IS INTENDED TO PREVENT UNAUTHORIZED AND
POSSIBLE HAZARDOUS USE BY CHILDREN AND
OTHERS_
B. TO turn saw ON ... stand to either side of the blade never in line with it ... insert finger under switch lever and pull END of lever out.
After turning switc_h ON, always allow the blade to come up to full speed before cutting.
Do not cycle the motor switch on and off rapidly, as this may cause the sawblade to loosen. !n the event this should ever occur, allow the sawblade to come to a complete stop and retighten the arbor nut normally, not excessively, Never leave the saw while the power is "'ON".
C. TO turn saw OFF ... PUSH lever in. Never leave
the saw until the cutting tool has come to a complete stop.
D. TO lock switch in OFF position ... hold switch IN with one hand ... REMOVE key wi_ other hand.
WARNING: FOR YOUR OWN SAFETY, LOWER BLADE OR OTHER CUTTING TOOL BELOW
TABLE SURFACE. (IF BLADE IS TILTED, RETURN IT TO VERTICAL (90 °) POSITION).
ALWAYS LOCK THE SWITCH "OFF", WHEN SAW IS NOT IN USE ... REMOVE KEY AND KEEP IT IN ASAFE PLACE ... ALSO ,.. IN
THE EVENT OF A POWER FAILURE (ALL OF YOUR LIGHTS GO OUT) TURN SWITCH OFF
... LOCK IT AND REMOVE THE KEY. THIS WILL PREVENT THE SAW FROM STARTING UP
AGAIN WHEN THE POWER COMES BACK ON,
@
KEY
(YELLOWPLASTIC)
2O