Soleus Air KFHHP-22 service manual Disassemble filter, Disassemble guide louver

Page 15

7Disassembly procedures

Disassembly procedures for indoor unit

Procedures and pictures

Disassembly front panel

(Refer to figure 7-1)

filter

electrical box top cover screw

Disassemble filter

Push filter inside and pull it upward.Take the filter away (Refer to 7-2)

front panel

hook

Disassemble guide louver

Bend the guide louver with strength and let out the hook

(Refer to figure 7-3)

hook

guide louver

-15-

Image 15
Contents Model Remarks Introduction and featuresKFHHP-22 Specifications and technical parametersKFHHP-22-OD Outdoor unit Components name Indoor unitOverall and installation dimension of indoor unit Overall and installation dimensionNutGgggg Overall and installation dimension of outdoor unitKFHHP-22 Temperature parameters Fundamental functionOther control Communication failure Fan mode Parameters of temperatureCool mode Dehumidifying modeDefrosting process Time-delay protection of compressorHigh exhausting gas temp. protection of compressor Current protection function Overcurrent protection Module protection Testing of malfunction of temp. sensor and IPM overheating Frequency demultiplying, limitation of current control Communication failureD11 Status of indicator in outdoor unitD17 Disassemble guide louver Disassemble filterDisassemble front case Disassemble electrical box coverDisassemble electrical box Disassemble evaporator assy Disassemble water trayDisassemble cross flow fan Disassemble motorOperating procedures /pictures Disassembly procedures for outdoor unitDisassemble housing case Disassemble motor and motor support Disassemble 4-way valveDisassemblle capillary Operating procedures/picturesIndoor unit Exploded view and components&part listComponents and part list of indoor unit KFHHP-22-OD PCB JGP011 Components and part list of outdoor unitReplace the controller Change battery TroubleshootingPage Poor cooling heating effect Improper setting of temperature Wrap and tight it again Malfunction display section Rectifying bridge, reactor, capacitance etc. is ok