Soleus Air KFHHP-22 service manual Disassemble water tray, Disassemble evaporator assy

Page 17

Disassemble water tray

Unloose the clasp fixing water tray;lift and disassemble it (Refer to figure 7-7)

hook

Disassemble evaporator assy

Unscrew 2 screws on the clamp and remove the clamp unscew the 2 screws fixing evaporator on left and right side.

Take out the evaporator by you hand and push it backward to let out the side clasps from the groove.Take out the evaporator carefully

,protect- the connecting pipe

(Refer to figure 7-8,7-9,7-10)

clasp

water tray

clamp

screws

screws

-17-

Image 17
Contents Model Remarks Introduction and featuresKFHHP-22 Specifications and technical parametersKFHHP-22-OD Outdoor unit Components name Indoor unitOverall and installation dimension of indoor unit Overall and installation dimensionNutGgggg Overall and installation dimension of outdoor unitKFHHP-22 Other control Temperature parametersFundamental function Communication failure Cool mode Parameters of temperatureDehumidifying mode Fan modeHigh exhausting gas temp. protection of compressor Time-delay protection of compressorCurrent protection function Overcurrent protection Defrosting processFrequency demultiplying, limitation of current control Testing of malfunction of temp. sensor and IPM overheatingCommunication failure Module protectionD11 Status of indicator in outdoor unitD17 Disassemble guide louver Disassemble filterDisassemble electrical box Disassemble front caseDisassemble electrical box cover Disassemble evaporator assy Disassemble water trayDisassemble cross flow fan Disassemble motorOperating procedures /pictures Disassembly procedures for outdoor unitDisassemble housing case Disassemble motor and motor support Disassemble 4-way valveDisassemblle capillary Operating procedures/picturesIndoor unit Exploded view and components&part listComponents and part list of indoor unit KFHHP-22-OD PCB JGP011 Components and part list of outdoor unitReplace the controller Change battery TroubleshootingPage Poor cooling heating effect Improper setting of temperature Wrap and tight it again Malfunction display section Rectifying bridge, reactor, capacitance etc. is ok