Soleus Air KFHHP-22 Disassembly procedures for outdoor unit, Operating procedures /pictures

Page 19

Disassembly procedures for outdoor unit

Operating procedures /pictures

Disassemble front side plate

front side plate

unsrew the 4 srews around the front side plate and take off it (Refer to figure 7-13)

srews

Disassemble top cover

Unsrew the srews around the top voer plate;lift the top cover and remove it

(Refer to figure 7-14)

srews

top cover

Disassemble rear grill

Unscrew the 4-self tapping screws on rear side plate srews and take off the grill.

rear grill

-19-

Image 19

Contents Model Remarks Introduction and featuresKFHHP-22 Specifications and technical parametersKFHHP-22-OD Outdoor unit Components name Indoor unitOverall and installation dimension of indoor unit Overall and installation dimensionNutGgggg Overall and installation dimension of outdoor unitKFHHP-22 Fundamental function Temperature parametersOther control Communication failure Fan mode Parameters of temperatureCool mode Dehumidifying modeDefrosting process Time-delay protection of compressorHigh exhausting gas temp. protection of compressor Current protection function Overcurrent protectionModule protection Testing of malfunction of temp. sensor and IPM overheatingFrequency demultiplying, limitation of current control Communication failureD11 Status of indicator in outdoor unitD17 Disassemble guide louver Disassemble filterDisassemble electrical box cover Disassemble front caseDisassemble electrical box Disassemble evaporator assy Disassemble water trayDisassemble cross flow fan Disassemble motorOperating procedures /pictures Disassembly procedures for outdoor unitDisassemble housing case Disassemble motor and motor support Disassemble 4-way valveDisassemblle capillary Operating procedures/picturesIndoor unit Exploded view and components&part listComponents and part list of indoor unit KFHHP-22-OD PCB JGP011 Components and part list of outdoor unitReplace the controller Change battery TroubleshootingPage Poor cooling heating effect Improper setting of temperature Wrap and tight it again Malfunction display section Rectifying bridge, reactor, capacitance etc. is ok