Soleus Air KFHHP-22 service manual Disassemble housing case

Page 20

Disassemble housing case

unsrew the screws around the housing case and take off it screws

housing case

Disassemble electrical box

Screw out the 2 screws fixing the electrical box;

lift it and remove it.

(Refer to figure 7-17,7-18)

Disassemble right side plate

unscrew the 7 srews in right side plate,condensor side plate and valve support;lift right side plate and remove it.

(Refer to 7-19)

screws

cover of electrical box

screws

screws

right side plate

-20-

Image 20

Contents Introduction and features Model RemarksSpecifications and technical parameters KFHHP-22KFHHP-22-OD Components name Indoor unit Outdoor unitOverall and installation dimension Overall and installation dimension of indoor unitOverall and installation dimension of outdoor unit NutGggggKFHHP-22 Other control Temperature parametersFundamental function Communication failure Parameters of temperature Cool modeDehumidifying mode Fan modeTime-delay protection of compressor High exhausting gas temp. protection of compressorCurrent protection function Overcurrent protection Defrosting processTesting of malfunction of temp. sensor and IPM overheating Frequency demultiplying, limitation of current controlCommunication failure Module protectionStatus of indicator in outdoor unit D11D17 Disassemble filter Disassemble guide louverDisassemble electrical box Disassemble front caseDisassemble electrical box cover Disassemble water tray Disassemble evaporator assyDisassemble motor Disassemble cross flow fanDisassembly procedures for outdoor unit Operating procedures /picturesDisassemble housing case Disassemble 4-way valve Disassemble motor and motor supportOperating procedures/pictures Disassemblle capillaryExploded view and components&part list Indoor unitComponents and part list of indoor unit KFHHP-22-OD Components and part list of outdoor unit PCB JGP011Troubleshooting Replace the controller Change batteryPage Poor cooling heating effect Improper setting of temperature Wrap and tight it again Malfunction display section Rectifying bridge, reactor, capacitance etc. is ok