Appliance details
• CO2 level set from factory, see chapter 5.4.
Dimensions
•Depth (in): 8 ½” (220 mm)
•Width (in): 15 ¾” (400 mm)
•Height (in): 23 ½” (600 mm)
•Weight: 47 pounds (21 kg).
Gas types
Natural Gas. LP Gas.
Converting the gas type can only be done by a certified gas technician with a calibrated CO2 analyzer.
Call Bosch Water Heating for conversion information.
Voltage
120 V AC (50/60 Hz)
6 ft power supply cord
Amperage
Idle - 40 mA
Operation - ≤ 2.5 A
Noise
≤50 db (A)
Safety devices
•Flame failure device (ionization flame rod sensor)
•Pressure relief valve (supplied with heater)
•Over heat prevention (temperature limiter).
Water resistant
IP X4 (protection against water drops)
2.3Unpacking the 2400 E heater
Before installing the unit, be certain you have the correct heater for your type of Gas - Propane or Natural Gas. Identification labels are found on the shipping box, and on the rating plate sticker which is located on the right side panel of the cover.
•Exhaust vent adaptor (with 4 screws and gasket provided)
•Condensate drain tube kit
•Combustion air inlet adaptor (with 3 screws and gas- ket provided)
•Plastic decal shields for covering front cover screws and control panel, installer should affix these decals to the front of the unit after installation is complete. See Fig. 3
•Installation manual (replacement manuals can be downloaded at www.boschhotwater.com)
•Product registration card
•Energy Guide label.
Please complete and return the enclosed product registration card.
The 2400 E is not approved or designed for:
•Manufactured (mobile) homes, RV's, boats or any mobile installation.
•Heating or other recirculating/pumping applications*
•Solar/preheat backup or high temperature booster use.
*This includes domestic hot water circulator pump loop systems that may be installed in home hot water system prior to installing this unit. An approved recirculation design can be found in chapter 3.9. The use of a small electric
To remove front cover
•Loosen the two Philips head screws located on front panel (beneath plastic decal shields if they are already attached, see Fig. 3)
•Lift front cover panel upward and remove.
Plastic decals
Fig. 2 Rating plate sticker
A Serial number
BType of gas
The box includes:
• Pressure relief valve (150 psi / 200,000 Btu rating)
Fig. 3 Remove front cover
• Bracket for wall hanging the heater
6 720 608 263 | 5 |