Model SB1019 | P R E P A R A T I O N | For Machines Mfg. Since 8/09 |
Test Run
After all preparation steps have been completed, the machine and its safety features must be tested to ensure correct operation. If you discover a problem with the operation of the machine or its safety components, do not operate it further until you have resolved the problem.
Note: Refer to Troubleshooting on Page 35 for solutions to common problems that may occur with
To test run your machine:
1.Read and follow the safety instructions at the beginning of the manual, take the re- quired safety precautions, and make sure the machine is assembled set up properly.
2.Clear away all tools and objects used during assembly and preparation.
3.Open the downfeed valve (Figure 13) and allow the headstock to travel all the way down. If the blade contacts the machine base, adjust the downfeed stop bolt.
Downfeed
Valve 
Figure 13. Downfeed valve.
4.Connect the machine to the power source.
5.Put on safety glasses and secure loose clothing or long hair.
6.Lift the headstock by the handle to the raised position, then close the downfeed valve to prevent it from lowering.
7.Start the bandsaw while keeping your finger near the ON/OFF switch at all times during the test run. The bandsaw should run smoothly with little or no vibration.
—If you suspect any problems, immediately turn the bandsaw OFF, disconnect it from power, and correct the problem before continuing.
—If you need any help with your bandsaw call our Tech Support at (360)
Inspections &
Adjustments
The following list of adjustments were performed at the factory before your machine was shipped. If you find that the adjustments are not set according to the procedures in this manual or your personal preferences,
• | Blade Tracking | Page 38 |
• | Blade Guide Bearings | Page 39 |
• | Squaring the Blade | Page 39 |