Grizzly G4015Z owner manual Lathe Chuck Removal, Please see Figure

Page 16

Lathe Chuck Removal

ALWAYS place a piece of plywood over the bed-ways of the lathe before removing or installing a lathe chuck. This helps by covering the sharp cor- ners of the bed, pro- tecting your hands and fingers from a pinch injury.

Never leave a chuck key in the chuck when it is not in use. If the machine is accidental- ly started, the chuck key can become a pro- jectile and cause serious personal injury.

To remove a chuck:

1.Place a piece of plywood across the lathe bed and position it just under the chuck. The board should be at least 8" wide and 10" long.

2.Locate the 3 socket head cap screws on the back of the back plate and remove 2 of them.

Please see Figure 7.

3.Remove the last screw, while making sure to support the chuck with one hand. The chuck may come off as the last screw is removed so it is important that you are ready to sup- port its weight.

4.Remove the chuck.

-14-	G4015Z Lathe/Mill

Image 16

Contents Model G4015Z Combination LATHE/MILL Page Table Of Contents Safety Safety Instructions For Power ToolsAMP Rating Additional Safety Instructions For Lathe/Mills Never Leave a Chuck KEY in the Drill Chuck or Lathe ChuckCircuit Requirements 110V Operation Extension CordsGrounding Typical 110V plug and outlet G4015Z Lathe/MillIntroduction CommentaryUnpacking Piece InventoryLifting Machine Use only these lifting points G4015Z Lathe/MillClean Up Site ConsiderationsIdentification Machine TermsHandwheel Assembly & SetupHand Crank Lathe Chuck Place roll pin in hole and tap with hammerLathe Chuck Removal Please see FigureTo install a chuck If the chuck is still tight on the spindleDead Center Using a center to check tool bit height G4015 Lathe/Mill Tool PostDrill Chuck Removal Drill ChuckUnplug the machine Drill Press Mounting Lathe MountingMachine Vise Sliding the tool post offLathe Controls Lathe SpeedsExample To change belt position Unplug the machineFeed Selection Feed Lever Never move the feed rate lever while machine is runningHalf Nut Carriage Controls Carriage LockTailstock Controls Drill Press Controls Quill Lock Lever Fine Down FeedAdjustments GibsHead Stock This bolt locks the apron in placeTailstock Bar stock mounted on centers G4015Z Lathe/MillTailstock offset adjustment screw G4015Z Lathe/Mill Operations Control PanelTest Run Before starting the machineFeed Rates Reading the ChartsSelection Changing Gears Swing gears in lower positionFlats on bushing align with slot Tooth gear installed at a G4015 Lathe/Mill Inch Threading127 tooth combination gear Metric Threading Gear D is turned so hub is on outside G4015 Lathe/MillMaintenance LubricationBearing Preload Tailstock oiling pointsClosure Machine Data Sheet Your Notes 856 852 857 880 Link Board 872 871 601 606 Clutch 127 119 Motor 142 Body 218 223 305 304 301 222 214 216 Draw BAR G4015 Lathe/Mill Locking HUB 547 Lock HUB Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC