Grizzly G4015Z owner manual If the chuck is still tight on the spindle, To install a chuck

Page 17

Chuck and back plate join here.

Socket head cap screw

Figure 7. Remove screw from the back of chuck.

If the chuck is still tight on the spindle:

Tap the edge of the chuck with a rubber or wood- en mallet while supporting the bottom of the chuck with your free hand. If the chuck does not immediately come off, rotate the spindle approxi- mately 60˚ and tap again.

To install a chuck:

1.Place a piece of plywood across the lathe bed and position it just under the spindle.

2.Place a socket head screw into one of the holes in the back plate. Lift the chuck up to the spindle and align the threaded hole in the back of the chuck with the screw.

3.While supporting the weight of the chuck, turn the screw 3 turns. Do not tighten at this time.

4.Rotate the spindle and repeat step 3 on the last two screws.

5.Return to the first screw and tighten it a little more. Tighten the other screws as well but only enough that the gap between the chuck and the back plate remains even.

6.Finally, tighten all three screws until the gap between the chuck and the back plate is closed.

 

 

 

 

 

 

 

 

 

 

 

 

G4015Z Lathe/Mill

-15-

Image 17
Contents Model G4015Z Combination LATHE/MILL Page Table Of Contents Safety Instructions For Power Tools SafetyAMP Rating Never Leave a Chuck KEY in the Drill Chuck or Lathe Chuck Additional Safety Instructions For Lathe/Mills110V Operation Extension Cords Circuit RequirementsTypical 110V plug and outlet G4015Z Lathe/Mill GroundingCommentary IntroductionPiece Inventory UnpackingUse only these lifting points G4015Z Lathe/Mill Lifting MachineSite Considerations Clean UpMachine Terms IdentificationHand Crank Assembly & SetupHandwheel Place roll pin in hole and tap with hammer Lathe ChuckPlease see Figure Lathe Chuck RemovalIf the chuck is still tight on the spindle To install a chuckDead Center Tool Post Using a center to check tool bit height G4015 Lathe/MillUnplug the machine Drill ChuckDrill Chuck Removal Lathe Mounting Drill Press MountingSliding the tool post off Machine ViseLathe Speeds Lathe ControlsExample To change belt position Unplug the machineNever move the feed rate lever while machine is running Feed Selection Feed LeverCarriage Lock Half Nut Carriage ControlsTailstock Controls Drill Press Controls Fine Down Feed Quill Lock LeverGibs AdjustmentsThis bolt locks the apron in place Head StockBar stock mounted on centers G4015Z Lathe/Mill TailstockTailstock offset adjustment screw G4015Z Lathe/Mill Control Panel OperationsBefore starting the machine Test RunSelection Reading the ChartsFeed Rates Swing gears in lower position Changing GearsFlats on bushing align with slot Inch Threading Tooth gear installed at a G4015 Lathe/Mill127 tooth combination gear Gear D is turned so hub is on outside G4015 Lathe/Mill Metric ThreadingLubrication MaintenanceTailstock oiling points Bearing PreloadClosure Machine Data Sheet Your Notes 856 852 857 880 Link Board 872 871 601 606 Clutch 127 119 Motor 142 Body 218 223 305 304 301 222 214 216 Draw BAR G4015 Lathe/Mill Locking HUB 547 Lock HUB Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC