Grizzly G4015Z owner manual Test Run, Before starting the machine

Page 34

Test Run

Inspect your machine for loose nuts and bolts, and ensure no tools are left in or around the machine

before reconnecting power.

Now that the lathe is securely in place and you’ve read the safety guidelines, it’s time to give the machine a test run.

Before starting the machine:

1.Make sure the machine is properly ground- ed, the power switch is in the “OFF” position and the reversing switch is selected for for- ward.

2.Inspect the machine to ensure that all hand tools are out of the way, guards are in place and nothing is impeding the movement of the chuck. Check this by rotating the chuck by hand.

3.Rotate the System Reset Button and allow it to pop out. Push the start button on the con- trol panel while keeping a finger poised over the stop button. The machine should run smoothly with little or no vibration or rubbing noises when it starts. Strange or unnatural noises should be investigated and corrected before operating the machine further.

If the direction is reversed, contact our service department for further instructions.

4.If the lathe/mill is running correctly, push the stop button, wait for the machine to come to a complete stop and take some time to review the various controls.

Keep clothing rolled up and out of the way of machinery and keep hair pulled back.

Disconnect power to the machine when perform- ing any adjustments or maintenance. Failure to do this may result in seri- ous personal injury.

Wear safety glasses dur- ing all operations on the shaper. Failure to com- ply may result in serious personal injury.

-32-

G4015Z Lathe/Mill

Image 34
Contents Model G4015Z Combination LATHE/MILL Page Table Of Contents Safety Safety Instructions For Power ToolsAMP Rating Additional Safety Instructions For Lathe/Mills Never Leave a Chuck KEY in the Drill Chuck or Lathe ChuckCircuit Requirements 110V Operation Extension CordsGrounding Typical 110V plug and outlet G4015Z Lathe/MillIntroduction CommentaryUnpacking Piece InventoryLifting Machine Use only these lifting points G4015Z Lathe/MillClean Up Site ConsiderationsIdentification Machine TermsHandwheel Assembly & SetupHand Crank Lathe Chuck Place roll pin in hole and tap with hammerLathe Chuck Removal Please see FigureTo install a chuck If the chuck is still tight on the spindleDead Center Using a center to check tool bit height G4015 Lathe/Mill Tool PostDrill Chuck Removal Drill ChuckUnplug the machine Drill Press Mounting Lathe MountingMachine Vise Sliding the tool post offExample Lathe ControlsLathe Speeds To change belt position Unplug the machineFeed Selection Feed Lever Never move the feed rate lever while machine is runningHalf Nut Carriage Controls Carriage LockTailstock Controls Drill Press Controls Quill Lock Lever Fine Down FeedAdjustments GibsHead Stock This bolt locks the apron in placeTailstock Bar stock mounted on centers G4015Z Lathe/MillTailstock offset adjustment screw G4015Z Lathe/Mill Operations Control PanelTest Run Before starting the machineFeed Rates Reading the ChartsSelection Changing Gears Swing gears in lower positionFlats on bushing align with slot Tooth gear installed at a G4015 Lathe/Mill Inch Threading127 tooth combination gear Metric Threading Gear D is turned so hub is on outside G4015 Lathe/MillMaintenance LubricationBearing Preload Tailstock oiling pointsClosure Machine Data Sheet Your Notes 856 852 857 880 Link Board 872 871 601 606 Clutch 127 119 Motor 142 Body 218 223 305 304 301 222 214 216 Draw BAR G4015 Lathe/Mill Locking HUB 547 Lock HUB Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC