Grizzly G4015Z owner manual Assembly & Setup, Handwheel, Hand Crank

SECTION 5: ASSEMBLY & SETUP

This section will cover the basics in assembly and setup. We recommend you complete assembly in the order in which it is presented to achieve the best results.

Do not connect the machine to power at this time. The machine must remain unplugged throughout the entire

assembly process. Failure to do this may result in serious per- sonal injury.

Handwheel

The handwheel for the apron must be installed.

1.Remove the acorn nut and washer from the cross feed Lead Screw.

2.Slide the handwheel onto the cross feed Lead Screw. Note the key way that is in the bore of the handwheel and orient it so it aligns with the key on the cross feed Lead Screw.

3.Secure the handwheel with the acorn nut and washer.

4.Secure the handle for the handwheel with a screw driver as in Figure 4.

Figure 4. Secure the handle with a screw driver.

Hand Crank

The hand crank for the longitudinal manual feed must be installed.

1.The end of the Lead Screw has a small hole that is cross-drilled near its end. The hand crank has a similar hole drilled into the edge of the center ball. Orient these holes to each other and slide the hand crank onto the end of the shaft.

2.Rotate the hand crank on the shaft until the holes align.

3.Place the 4mm roll pin into the hole as in Figure 5 and drive it in with a hammer.

-12- G4015 Lathe/Mill