To change belt position:
1.Unplug the machine.
2.Remove the Upper Belt Guard, loosen the cover securing stud and pivot the belt ten- sioner to relax tension on the belt. See
Figure 26.
3.While slowly turning a pulley, roll the belt up or down to the desired sheave. It is always easier to roll off of the larger pulley onto a smaller pulley. Do not allow fingers to become trapped between belt and pulley.
4.Pivot the belt tensioner until the belt is tight and secure the tensioner by tightening the stud.
5.Replace belt guard.
Figure 26. Loosen stud to pivot belt tensioner.
Quill Lock Lever
The height of the spindle can be locked with the Quill Lock Lever. Set the desired height with the Quill Lever and turn the lever down. The lever can be clearly seen on the bottom right hand cor- ner of Figure 27.
Fine Down Feed
The up and down motion of the drill press spin- dle is controlled just like any other drill press with a Quill Lever. But unlike most drill presses, the Model G4015Z is supplied with a Fine Down Feed knob, indicated by the arrow in Figure 27.
To activate this feature, rotate the Quill Lever while depressing the black knob in the middle of the center of the hub as in Figure 27. The knob will engage and the spindle will no longer move using the Quill Lever. Rotating the Fine Down Feed knob in a clockwise direction will cause the spindle to go down. To disengage this feature, rotate the Fine Down Feed knob and pull on the knob in the center of the hub. Rotating the hand- wheel will always aid in engaging and disengag- ing this feature.
Figure 27. Move the handle while depressing knob.
G4015Z Lathe/Mill |