Grizzly G9249 owner manual Feed Rate Gears, Apron Gearbox, To lubricate the feed rate gears

Feed Rate Gears

Lubricant	Frequency	Qty
Multi-Purpose Gear	Every	As
Grease	40 Hours	need-
	of Operation	ed

To lubricate the feed rate gears:

1.Use a 5mm hex wrench to remove the four cap screws securing the feed rate gearbox cover (see Figure 83).

Cap

Screws

(2 of 4)

Aligning Pins

Figure 83. Feed rate gearbox cover.

2.Carefully pull the cover from the machine tak- ing care not to bend the aligning pins.

3.Use a brush to apply a thin coat of grease to the gear teeth.

4.Use the aligning pins to properly position the cover on the machine, then secure it with the four cap screws.

Apron Gearbox

Lubricant	Frequency	Qty
ISO 68 SAE 20W	Every	As need-
Bearing and Gear	40 Hours	ed
Lubricant	of Operation

Remove the oil plug on top of the apron shown in Figure 84, add lubricant, then replace the oil plug. The apron gearbox reservoir holds approximately 3/4 of a pint of lubricant. Excess lubricant will leak from the front of the apron.

Oil Plug

Ball Oilers

Figure 84. Apron lubrication points.

G9249  12" x 37" Belt Drive Gap Bed Lathe -49-