Carrier R-410A manual Filter Removal/Replacement

Replacing Filters — Filters can be removed and in- stalled from either side of the unit. Install new filters in units that have one fan as follows:

1. Remove the side access panel (retain screws).

2. Remove the filter retainer clip (see Fig. 25).

3. Remove old filters by lifting and tilting them out of the filter track. See Fig. 15 and 26. Use the factory-supplied filter hook to slide filters within reach for removal. The filter hook is shipped inside the unit in the filter track

4. Reverse the procedure to install new filters.

UNIT OPERATION HAZARD

Failure to follow this caution could cause equipment damage.

Do not operate unit without air filters.

Fig. 26 — Filter Removal/Replacement

FILTER

RETAINE

CLIP

Fig. 25 — Remove Filter Retainer Clip

24