Carrier R-410A manual Medium-Static Drive Data, 60 Hz SI, High-Static Drive Data, 60 Hz SI

Table 9E — Medium-Static Drive Data, 60 Hz — SI

UNIT	40RUA*25	40RUA*28	40RUA*30
	40RUS*25	40RUS*28	40RUS830
MOTOR DRIVE
Motor Pulley Pitch Diameter (mm)	109.2-	109.2-	109.2-
	134.6	134.6	134.6
Pulley Factory Setting	3.0	3.0	3.0
Full Turns Open
FAN DRIVE
Pulley Pitch Dia (mm)	239	239	239
Pulley Bore (mm)	36.5	49.2	49.2
Belt No. — Section	1—B	2—B†	2—B†
Belt Pitch (mm)	1062	(2) 986	(2) 986
		(2) 1011	(2) 1011
FAN SPEEDS (r/s)
Factory Setting	14.7	14.7	14.7
Range	13.3-16.4	13.3-16.4	13.3-16.4
Max Allowable Speed (r/s)	20.0	18.3	18.3
Change per 1/2 Turn of	0.255	0.255	0.255
Moveable Motor Pulley
Flange
MAX FULL TURNS FROM	6	6	6
CLOSED POSITION
SHAFTS CENTER DISTANCE (mm)	232-279	169-240	169-240

†Four belts shipped with unit. Use correct set of 2 belts sized according to the pully setting.

Table 9F — High-Static Drive Data, 60 Hz — SI

UNIT	40RUA*25	40RUA*28	40RUA*30
	40RUS*25	40RUS*28	40RUS*30
MOTOR DRIVE
Motor Pulley Pitch Diameter (mm)	109.2-	109.2-	109.2-
	134.6	134.6	134.6
Pulley Factory Setting	3.0	3.0	3.0
Full Turns Open
FAN DRIVE
Pulley Pitch Dia (mm)	188	203†	203
Pulley Bore (mm)	36.5	49.2	49.2
Belt No. — Section	2—B	2—B	2—B
Belt Pitch (mm)	935	935	960
FAN SPEEDS (r/s)
Factory Setting	18.6	17.1	17.1
Range	16.9-	14.6-	14.6-
	20.0†	17.9	17.9
Max Allowable Speed (r/s)	20.0	18.3	18.3
Change per 1/2 Turn of	0.323	0.278	0.278
Moveable Motor Pulley
Flange
MAX FULL TURNS FROM	6	6	6
CLOSED POSITION
SHAFTS CENTER DISTANCE (mm)	207-255	169-240	169-240

†It is possible to adjust drive so that fan speed exceeds maximum allowable. DO NOT exceed 20 r/s.

29