BM 1619P06013
PLUNGE CUTS
Disconnect the plug from the power source before making adjustments. Set depth adjust- ment according to material to be cut. Tilt saw forward with cutting guide notch lined up with the line you’ve drawn. Raise the lower guard, using lift lever and hold the saw by the front and rear handles (Fig. 8).
With the blade just clearing the material to be cut, start the motor. Gradually lower the back end of saw using the front end of the foot as the hinge point.
!WARNING As blade starts cutting the material, release the lower
guard immediately. When the foot rests flat on the surface being cut, proceed cutting in forward direction to end of cut.
!WARNING Allow blade to come to a complete stop before lifting
the saw from cut. Also, never pull the saw backward since blade will climb out of the material and KICKBACK will occur.
Turn saw around and finish the cut in the normal manner, sawing forward. If corners of your pocket cut are not completely cut through, use a jigsaw or hand saw to finish the corners.
FIG. 8
FOOT
|
| LOWER GUARD |
LINE GUIDE | LIFT LEVER | |
CUTTING LARGE SHEETS
Large sheets and long boards sag or bend, depending on support. If you attempt to cut without leveling and properly supporting the piece, the blade will tend to bind, causing KICKBACK and extra load on the motor (Fig. 9).
Support the panel or board close to the cut, as shown in (Fig. 10). Be sure to set the depth of
the cut so that you cut through the sheet or board only and not the table or work bench. The
FIG. 9
WRONG
FIG. 10